- 您現在的位置：買賣IC網 > Datasheet目錄38 > AD650SD (Analog Devices Inc)IC V-F/F-V CONV 1MHZ 14-CDIP Datasheet資料下載
參數資料
| 型號： | AD650SD |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 15/20頁 |
| 文件大小： | 385K |
| 描述： | IC V-F/F-V CONV 1MHZ 14-CDIP |
| 標準包裝： | 1 |
| 類型： | 電壓至頻率和頻率至電壓 |
| 頻率 - 最大： | 1MHz |
| 全量程： | ±150ppm/°C |
| 線性： | ±0.1% |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 14-CDIP（0.300"，7.62mm） |
| 供應商設備封裝： | 14-CDIP |
| 包裝： | 管件 |
Data Sheet
AD650
Rev. E | Page 15 of 20
A second major difference is that the output only sinks 1 mA to
the negative supply. There is no pulldown stage at the output
other than the 1 mA current source used for the V-to-F
conversion. The op amp sources a great deal of current from the
positive supply, and it is internally protected by current limiting.
The output of the op amp can be driven to within 3 V of the
positive supply when it is not sourcing external current. When
sourcing 10 mA the output voltage can be driven to within 6 V
of the positive supply.
A third difference between this op amp and a normal device is
that the inverting input, Pin 3, is bias current compensated and
the noninverting input is not bias-current compensated. The
bias current at the inverting input is nominally zero, but can be
as much as 20 nA in either direction. The noninverting input
typically has a bias current of 40 nA that always flows into the
node (an npn input transistor). Therefore, it is not possible to
match input voltage drops due to bias currents by matching
input resistors.
The op amp has provisions for trimming the input offset
voltage. A potentiometer of 20 k?is connected from Pin 13 to
Pin 14 and the wiper is connected to the positive supply
through a 250 k?resistor. A potential of about 0.6 V is
established across the 250 k?resistor, and the 3 糀 current is
injected into the null pins. It is also possible to null the op amp
offset voltage by using only one of the null pins and by using a
bipolar current either into or out of the null pin. The amount of
current required is very smalltypically less than 3 糀. This
technique is shown in the Applications section of this data
sheet; the autozero circuit uses this technique.
The bipolar offset current is activated by connecting a 1.24 k?
resistor between Pin 4 and the negative supply. The resulting
current delivered to the op amp noninverting input is nominally
0.5 mA and has a tolerance of ?0%. This current is then used
to provide an offset voltage when Pin 2 is tied to ground through
a resistor. The 0.5 mA that appears at Pin 2 is also flowing
through the 1.24 k?resistor. An external resistor is used to
activate the bipolar offset current source to provide the lowest
tolerance and temperature drift of the resulting offset voltage.
It is possible to use other values of resistance between Pin 4 and
V
S
to obtain a bipolar offset current different from 0.5 mA.
Figure 19 shows the relationship between the bipolar offset
current and the value of the resistor used to activate the source.
礎
&
200
500
4000
EXTERNAL RESISTOR
400
600
800
1000
1000
1500
2000
2500
3000
3500
Figure 19. Bipolar Offset Current vs. External Resistor
相關PDF資料 |
PDF描述 |
|---|---|
| AD652SQ | IC V-F CONV SYNCH MONO 5V 16CDIP |
| AD654JNZ/+ | IC CONV VOLT-FREQ 500KHZ 8DIP |
| AD7740YRM | IC CONVERTER V TO FREQ 8-MSOP |
| ADM1070ARTZ-REEL7 | IC CTRLR HOTSWAP -48V SOT23-6 |
| ADM1073ARU-REEL | IC CTRLR HOTSWAP -48V 14TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD650SD/883B | 功能描述:電壓頻率轉換及頻率電壓轉換 IC - V/F CONVERTER IC RoHS:否 制造商:Texas Instruments 全標度頻率:4000 KHz 線性誤差:+/- 1 % FSR 電源電壓-最大: 電源電壓-最小: 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 安裝風格:Through Hole 封裝 / 箱體:PDIP-14 封裝:Tube |
| AD650SD-883B | 制造商:AD 制造商全稱:Analog Devices 功能描述:Voltage-to-Frequency and Frequency-to-Voltage Converter |
| AD650TYHHLBOX | 制造商:Advanced Micro Devices 功能描述:AMD A-SERIES APU A8-6500T X4 3100MHZ 4MB FM2 45W PIB - Boxed Product (Development Kits) |
| AD651AQ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Converter |
| AD651SQ | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。