- 您現在的位置：買賣IC網 > PDF目錄98231 > TL3577-ADJIKTTRG3 (TEXAS INSTRUMENTS INC) 6 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PSSO5 PDF資料下載
參數資料
| 型號： | TL3577-ADJIKTTRG3 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 6 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PSSO5 |
| 封裝： | PLASTIC, D2PAK, TO-263, 5 PIN |
| 文件頁數： | 6/21頁 |
| 文件大?。?/td> | 431K |
| 代理商： | TL3577-ADJIKTTRG3 |
www.ti.com
0.3
0.4 0.45
0.35
0.5 0.6 0.7 0.8 0.9 1.0
1.5
2.0
2.5
3.0
20
30
35
25
40
45
50
60
70
80
90
100
200
150
L47
L68
L100
L150
L220
L330
H2200
L680
H1500
H1000
H680
H470
H330
H220
H150
L470
E
T
(V
s)
I
(A)
IND,DC
100-kHz CURRENT-MODE SIMPLE STEP-UP/FLYBACK SWITCHING REGULATOR
SLVS633 – OCTOBER 2006
B. Identify Inductor Value
1. From Figure 6, identify the inductor code for the region indicated by the intersection of E
T and I
IND,DC.
This code gives the inductor value in microhenries. The L or H prefix signifies whether the inductor is
rated for a maximum E
T of 90 Vs (L) or 250 Vs (H).
2. If D < 0.85, go to step C. If D
≥ 0.85, calculate the minimum inductance needed to ensure the switching
regulator’s stability:
If Lmin is smaller than the inductor values found in step B1, go on to step C. Otherwise, the inductor value
found in step 1, above, is too low; an appropriate inductor code should be obtained from Figure 6 as
follows:
a.
Find the lowest-value inductor that is greater than Lmin.
b.
Find where E
T intersects this inductor value to determine if it has an L or H prefix. If E T intersects
both the L and H regions, select the inductor with an H prefix.
C. Inductor Selection
Select an inductor from Table 2 which cross references the inductor codes to the part numbers of the three
different manufacturers. The inductors listed in Table 2 have the following characteristics:
AIE (ferrite, pot-core inductors): Benefits of this type are low electromagnetic interference (EMI), small
physical size, and very low power dissipation (core loss).
Pulse (powdered iron, toroid core inductors): Benefits are low EMI and ability to withstand E
T and peak
current above rated value better than ferrite cores.
Renco (ferrite, bobbin-core inductors): Benefits are low cost and best ability to withstand E
T and peak
current above rated value. Be aware that these inductors generate more EMI than the other types, and this
may interfere with signals sensitive to noise.
A.
This chart assumes that the inductor ripple current inductor is approximately 20% to 30% of the average inductor
current (when the regulator is under full load). Greater ripple current causes higher peak switch currents and greater
output ripple voltage. Lower ripple current is achieved with larger value inductors. The factor of 20% to 30% is
chosen as a convenient balance between the two extremes.
Figure 6. Inductor Selection Graph
14
相關PDF資料 |
PDF描述 |
|---|---|
| TL3577-ADJIKTTR | 6 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PSSO5 |
| TL431ILP/1H | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 2.5 V, PBCY3 |
| TL431AIX/11H-E3 | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 2.5 V, PSSO3 |
| TL431AIU2/48H | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 2.5 V, PDSO3 |
| TL431AIU1/48H | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 2.5 V, PDSO3 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TL35A | 功能描述:測試引線 TEST LEAD WITH ALL RoHS:否 制造商:Pomona Electronics 設備類型:Patch Cords 連接器類型:Banana plug (stackable) on both ends 長度:60 in 顏色:Black |
| TL35B | 功能描述:測試引線 TEST LEAD W/ALLIGATOR CLIPS-CE RoHS:否 制造商:Pomona Electronics 設備類型:Patch Cords 連接器類型:Banana plug (stackable) on both ends 長度:60 in 顏色:Black |
| TL36 | 功能描述:測試引線 TEST LEADS W/CLIPS RoHS:否 制造商:Pomona Electronics 設備類型:Patch Cords 連接器類型:Banana plug (stackable) on both ends 長度:60 in 顏色:Black |
| TL-36 | 制造商:B&K Precision Corporation 功能描述: |
| TL360W | 制造商:General Tools 功能描述:All Weather Test Leads 制造商:General Tools 功能描述:TEST LEADSALL WEATHER |
發布緊急采購，3分鐘左右您將得到回復。