国产精品成人VA在线观看-国产乱妇乱子视频在播放-国产日韩精品一区二区三区在线-国模精品一区二区三区

參數資料
型號: TLC320AC02IFN
廠商: TEXAS INSTRUMENTS INC
元件分類: 模擬信號調理
英文描述: SPECIALTY ANALOG CIRCUIT, PQCC28
封裝: PLASTIC, LCC-28
文件頁數: 20/86頁
文件大小: 471K
代理商: TLC320AC02IFN
2–13
2.14.5
Midpoint Voltages (ADC VMID and DAC VMID)
Since the device operates at a single-supply voltage, two midpoint voltages are generated for internal signal
processing. ADC VMID is used for the ADC channel reference, and DAC VMID is used for the DAC channel
reference. Two references minimize channel-to-channel noise and crosstalk. ADC VMID and DAC VMID
must be buffered when used as a reference for external signal processing.
2.15 Device Functions
2.15.1
Phase Adjustment
In some applications, such as modems, the device sampling period may require an adjustment to
synchronize with the incoming bit stream to improve the signal-to-noise ratio. The TLC320AC02 can adjust
the sampling period through the use of the A
register and the control bits.
2.15.1.1 Phase-Adjustment Control
A phase adjustment is a programmed variation in the sampling period. A sampling period is adjusted
according to the data value in the A
register, and the phase adjustment is that number of master clocks
(MCLK). An adjustment is made during device operation with data bits D01 and D00 in the primary
communication, with data bits DS15 and DS14 in the secondary word or in combination with the hardware
terminals FC1 and FC0 (see Table 2 – 3). This adjustment request is latched on the rising edge of the next
internal frame-sync interval and is only valid for the next sampling period. To repeat the phase adjustment,
another phase request must be initiated.
2.15.1.2 Use of the A
′ Register for Phase Adjustment
The A
register value makes slight timing adjustments to the sampling period. The sampling period
increases or decreases according to the sign of the programmed A
register value and the state of data bits
D01 and D00 in the primary data word.
The general equation for the conversion frequency is given in equation 16:
+
MCLK
(2
A register value
B register value)
" (A register value)
fs = conversion frequency
(16)
Therefore, if A
= 0, the device conversion (sampling) frequency and period is constant.
If a nonzero A
value is programmed, the sampling frequency and period responds as shown in Table 2–2.
Table 2–2. Sampling Variation With A
SIGN OF THE A
′ REGISTER VALUE
D01
D00
PLUS VALUE
(+)
NEGATIVE VALUE
(–)
0
1
(increase command)
Frequency decreases,
period increases
Frequency increases,
period decreases
1
0
(decrease command)
Frequency increases,
period decreases
Frequency decreases,
period increases
An adjustment to the sampling period, which must be requested through D01 and D00 of the primary data
word to DIN, is valid for the following sampling period only. When the adjustment is required for the
subsequent sampling period, it must be requested again through D01 and D00 of the primary data word.
For each request, only the sampling period occurring immediately after the primary data word request is
affected.
相關PDF資料
PDF描述
TLC320AC02CPMR SPECIALTY ANALOG CIRCUIT, PQFP64
TLC320AC02IPM SPECIALTY ANALOG CIRCUIT, PQFP64
TLC320AC02IFNR SPECIALTY ANALOG CIRCUIT, PQCC28
TLC320AD55CDW SPECIALTY ANALOG CIRCUIT, PDSO28
TLC320AD55CDWR SPECIALTY ANALOG CIRCUIT, PDSO28
相關代理商/技術參數
參數描述
TLC320AC02IFNR 功能描述:接口—CODEC SNGL CH Codec Bandwidth Indpendent RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel
TLC320AC02IPM 功能描述:接口—CODEC SNGL CH Codec Bandwidth Indpendent RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel
TLC320AC03CFNG4 制造商:Texas Instruments 功能描述:
TLC320AC03CFNR 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述:
TLC320AC03CPM 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述: