国产精品成人VA在线观看-国产乱妇乱子视频在播放-国产日韩精品一区二区三区在线-国模精品一区二区三区

參數資料
型號： W741E201
廠商： WINBOND ELECTRONICS CORP
元件分類： 微控制器/微處理器
英文描述： 4-BIT FLASH MICROCONTROLLER
中文描述： 4-BIT, FLASH, 4 MHz, MICROCONTROLLER, PDIP18
封裝： 0.300 INCH, PLASTIC, DIP-18
文件頁數： 17/84頁
文件大小： 541K
代理商： W741E201
Preliminary W741E20X
Publication Release Date: March 1998
- 17 -
Revision A1
Bit 0 = 0 RC.0 works as output pin; Bit 0 = 1 RC.0 works as input pin
Bit 1 = 0 RC.1 works as output pin; Bit 1 = 1 RC.1 works as input pin
Bit 2 = 0 RC.2 works as output pin; Bit 2 = 1 RC.2 works as input pin
Bit 3 = 0 RC.3 works as output pin; Bit 3 = 1 RC.3 works as input pin
At initial reset, port RC is input mode (PM4 = 1111B).
Port Mode 5 Register (PM5)
The port mode 5 register is organized as 4-bit binary register (PM5.0 to PM5.3). PM5 can be used to
control the input/output mode of port RD. PM5 is controlled by the MOV PM5, #I instruction. The bit
descriptions are as follows:
0
1
2
3
Note: W means write only.
PM5
w
w
w
w
Bit 0 = 0 RD.0 works as output pin; Bit 0 = 1 RD.0 works as input pin
Bit 1 = 0 RD.1 works as output pin; Bit 1 = 1 RD.1 works as input pin
Bit 2 = 0 RD.2 works as output pin; Bit 2 = 1 RD.2 works as input pin
Bit 3 = 0 RD.3 works as output pin; Bit 3 = 1 RD.3 works as input pin
At initial reset, the port RB is input mode (PM2 = 1111B).
Input/Output Ports RC, RD
Port RC consists of pins RC.0 to RC.3, and port RD consists of pins RD.0 to RD.3. At initial reset,
input/output ports RC and RD are both in input mode. When RC and RD are used as output ports, the
CMOS type is the only ouput driving type. Each pin of port RC or RD can be specified as input or
output mode independently by the PM4 and PM5 registers. The MOVA R, RC or MOVA R, RD
instructions operate the input functions and the MOV RC, R or MOV RD, R operate the output
functions. When the PEF, HEF, and IEF corresponding to the RC port are set, a signal change at the
specified pins of port RC will execute the hold mode release or interrupt subroutine. Port status register
0 (PSR0) records the status of port RC, and that can be read out and cleared by the MOV R, PSR0,
and CLR PSR0 instructions. Before the port mode of the RC port is changed from output mode to input
mode in the hold mode release and interrupt application, the output value must be preset to the same
as the system status to prevent the undesired signal change being accepted. When the interrupt of RC
port is accepted, the corresponding event flag (EVF.2) will be reset, but the content of PSR0 should not
be changed except the CLR PSR0 or MOV PEF,#I instruction being executed or performing the reset
function. In addition, the falling edge signal on the pin of port RC specified by the instruction MOV SEF,
#I will cause the device to exit the stop mode. The RD port is used as the I/O port only.
Refer to Figure
9, Figure 10 and the instruction table for more details.
相關PDF資料
PDF描述
W764M32V100SB 64Mx32 Flash Multi-Chip Package 3.0V Page Mode Flash Memory
W764M32V100SBC 64Mx32 Flash Multi-Chip Package 3.0V Page Mode Flash Memory
W764M32V100SBI 64Mx32 Flash Multi-Chip Package 3.0V Page Mode Flash Memory
W764M32V100SBM 64Mx32 Flash Multi-Chip Package 3.0V Page Mode Flash Memory
W764M32V120SB 64Mx32 Flash Multi-Chip Package 3.0V Page Mode Flash Memory
相關代理商/技術參數
參數描述
W741E202 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT FLASH MICROCONTROLLER
W741E203 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT FLASH MICROCONTROLLER
W741E204 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT FLASH MICROCONTROLLER
W741E205 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT FLASH MICROCONTROLLER
W741E20X 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT FLASH MICROCONTROLLER
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*