- 您現在的位置：買賣IC網 > PDF目錄363895 > W741E204 (WINBOND ELECTRONICS CORP) 4-BIT FLASH MICROCONTROLLER PDF資料下載
參數資料
| 型號： | W741E204 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 4-BIT FLASH MICROCONTROLLER |
| 中文描述： | 4-BIT, FLASH, 4.19 MHz, MICROCONTROLLER, PDSO20 |
| 封裝： | 0.300 INCH, SOP-20 |
| 文件頁數： | 6/84頁 |
| 文件大小： | 541K |
| 代理商： | W741E204 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁
Preliminary W741E20X
- 6 -
FUNCTIONAL DESCRIPTION
Program Counter (PC)
Organized as an 11-bit binary counter (PC0 to PC10), the program counter generates the addresses of
the 2048
×
16 on-chip flash EEPROM containing the program instruction. When the jump or subroutine
call instructions or the interrupt or initial reset conditions are to be executed, the address
corresponding to the instruction will be loaded into the program counter. The format used is shown
below.
ITEM
ADDRESS
INTERRUPT
PRIORITY
Initial Reset
000H
-
INT 0 (Divider)
004H
1st
INT 1 (Timer 0)
008H
2nd
INT 2 (Port RC)
00CH
3rd
INT 3 (
INT
pin)
014H
4th
INT 4 (Serial Port Input)
018H
5th
INT 5 (Serial Port Output)
01CH
6th
INT 6 (Timer 1)
020H
7th
JMP Instruction
XXXH
-
Subroutine Call
XXXH
-
Stack Register (STACK)
The stack register is organized as 11 bits
×
8 levels (first-in, last-out). When either a call subroutine or
an interrupt is executed, the program counter will be pushed onto the stack register automatically. At
the end of a call subroutine or an interrupt service subroutine, the RTN instruction must be executed to
pop the contents of the stack register into the program counter. When the stack register is pushed over
the eighth level, the contents of the first level will be lost. In other words, the stack register is always
eight levels deep.
Program Memory (flash EEPROM)
The flash EEPROM is used to store program codes; the look-up table is arranged as 2048
×
4 bits.
The first three quarters of flash EEPROM (000H to 5FFH) are used to store instruction codes only, but
the last quarter (600H to 7FFH) can store both instruction codes and the look-up table. Each look-up
table element is composed of 4 bits, so the look-up table can be addressed up to 2048 elements.
There are two registers (TABL and TABH) to be used in look-up table addressing and they are
controlled by MOV TABH, R and MOV TABL, R instructions. When the instruction MOVC R is
executed, the contents of the look-up table location address specified by TABH, TABL and ACC will be
read and transferred to the data RAM. Refer to the instruction table for more details. The organization
of the program memory is shown in Figure 1.
相關PDF資料 |
PDF描述 |
|---|---|
| W741E205 | 4-BIT FLASH MICROCONTROLLER |
| W741E201 | 4-BIT FLASH MICROCONTROLLER |
| W764M32V100SB | 64Mx32 Flash Multi-Chip Package 3.0V Page Mode Flash Memory |
| W764M32V100SBC | 64Mx32 Flash Multi-Chip Package 3.0V Page Mode Flash Memory |
| W764M32V100SBI | 64Mx32 Flash Multi-Chip Package 3.0V Page Mode Flash Memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W741E205 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT FLASH MICROCONTROLLER |
| W741E20X | 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT FLASH MICROCONTROLLER |
| W741E260 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT FLASH MICROCONTROLLER |
| W741L250 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT MICROCONTROLLER |
| W741L260 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT MICROCONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。