- 您現在的位置：買賣IC網 > PDF目錄363895 > W741E205 (WINBOND ELECTRONICS CORP) 4-BIT FLASH MICROCONTROLLER PDF資料下載
參數資料
| 型號： | W741E205 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 4-BIT FLASH MICROCONTROLLER |
| 中文描述： | 4-BIT, FLASH, 4 MHz, MICROCONTROLLER, PDSO28 |
| 封裝： | 0.300 INCH, SKINNY, PLASTIC, SOP-28 |
| 文件頁數： | 20/84頁 |
| 文件大小： | 541K |
| 代理商： | W741E205 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁
Preliminary W741E20X
- 20 -
Output Port RE
Output port RE can be used as an output of the internal RT port, or as a serial input/output port. The
control flow is shown in Figure 8. When bit 1 of port mode 3 register (PM3) equals to 0, port RE works
as an output of internal port RT. When the MOV RE, R instruction is executed, the data in the RAM will
be output to port RT through port RE. When RE works as a parallel output port, it provides a high sink
current to drive LEDs. When bit 1 of MR0 equals to 1, the RE port works as a serial input/output port,
and RE.0 to RE.3 are used as DOUT, CLKO, DIN, and CLKI, respectively. In this case, the DIN pin
will has a built-in pull-high resistor. The serial I/O functions are controlled by the instructions SOP R
and SIP R. The functions of the two instructions are described below:
(1) When the SIP R instruction is executed, the data will be loaded from the serial input buffer to the
ACC and RAM first, and bit 1 of port status register 2 will automatically be set to "1" (BUSYI = 1).
Then the CLKI pin will send out 8 clocks and the data from the DIN pin will be loaded to SIB at the
rising edge of the CLKI pin. After the 8 clocks have been sent, BUSYI
will be reset to "0" and EVF.5
will be set to "1." At this time, if IEF.5 has been set (IEF.5 = 1), an interrupt is executed; if HEF.5
has been set (HEF.5 = 1), the hold state is terminated. Users can check the status of PSR2.1
(BUSYI) to know whether the serial input process is completed or not. If a serial input process is not
completed, and the SIP R instruction is executed again, the data will be lost. The timing is shown in
Figure 11.
T1
T2
T3
T4
CLKI
(RE3)
Data latch
BUSYI
(PSR2.1)
EVF5
Ins.
DIN
(RE2)
SIP R
1
2
3
4
5
6
7
8
Notes : 1. These clocks at the CLKI pin are internal clock and its frequency is Fosc/2.
2. When the internal signal of the data latch equals to "1,"
then the data in SIB will be loaded into RAM and ACC.
Figure 11. Timing of the Serial Input Function (SIP R)
相關PDF資料 |
PDF描述 |
|---|---|
| W741E201 | 4-BIT FLASH MICROCONTROLLER |
| W764M32V100SB | 64Mx32 Flash Multi-Chip Package 3.0V Page Mode Flash Memory |
| W764M32V100SBC | 64Mx32 Flash Multi-Chip Package 3.0V Page Mode Flash Memory |
| W764M32V100SBI | 64Mx32 Flash Multi-Chip Package 3.0V Page Mode Flash Memory |
| W764M32V100SBM | 64Mx32 Flash Multi-Chip Package 3.0V Page Mode Flash Memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W741E20X | 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT FLASH MICROCONTROLLER |
| W741E260 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT FLASH MICROCONTROLLER |
| W741L250 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT MICROCONTROLLER |
| W741L260 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT MICROCONTROLLER |
| W7422-A | 制造商:Coilcraft Inc 功能描述:NOT RoHS. Transformer, for Motorola MC33374 |
發布緊急采購，3分鐘左右您將得到回復。