- 您現在的位置：買賣IC網 > PDF目錄363903 > W83877TD (WINBOND ELECTRONICS CORP) I/O chip disk drive adapter PDF資料下載
參數資料
| 型號： | W83877TD |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 外設及接口 |
| 英文描述： | I/O chip disk drive adapter |
| 中文描述： | MULTIFUNCTION PERIPHERAL, PQFP100 |
| 封裝： | LQFP-100 |
| 文件頁數： | 156/191頁 |
| 文件大小： | 1200K |
| 代理商： | W83877TD |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁當前第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁
W83877ATF
Publication Release Date: April 1998
- 152 -
Version 0.51
by the BIOS software and BM_RLD is set by the ACPI software, an SCI interrupt is raised. Writing a
1 to BM_CNTRL sets it to logic 1 and also sets BM_STS to logic 1; Writing a 0 to BM_CNTRL has no
effect. Writing a 1 to BM_STS clears it to logic 0 and also clears BM_CNTRL to logic 0; writing a 0 to
BM_STS has no effect.
8.3.2 Power Management Timer
In the ACPI specification, a power management timer is required. The power management timer is a
24-bit fixed rate free running count-up timer that runs off a 3.579545MHZ clock. The power
management timer has the corresponding status bit (TMR_STS) and enable bit (TMR_EN). The
TMR_STS bit is set any time the last bit of the timer (bit 23) goes from 0 to 1 or from 1 to 0. If the
TMR_EN bit is set, the setting of the TMR_STS bit will generate an SCI interrupt. Three registers are
used to read the timer value; they are located in the PM1 register block. The power management
timer has one enable bit (TMR_ON) to turn if on or off. The TMR_ON is located in GPE register
block. If it is cleared to 0, the power management timer function will not work. There are no timer
reset requirements, except that the timer should function after power-up. See the following figure for
an
illustration.
To SCI Logic
24 bit
counter
Bits (23-0)
TMR_STS
TMR_EN
TMR_ON
3.579545 MHz
24
TMR_VAL
8.4 ACPI Registers (ACPIRs)
The ACPI register model consists of the fixed register blocks that perform the ACPI functuions. A
register block may be a event register block which deals with ACPI events, or a control register block
which deals with control features. The ordering in the event register block is the status register,
followed by the enable register.
Each event register, if implemented, contains two egisters: a status register and an enable register,
both in 16-bit size. The status register indicates what defined function needs the ACPI System Control
Interrupt (SCI). When the hardware event occurs, the defined status bit is set. However, to generate
the SCI, the associated enable bit must be set. If the enable bit is not set, the software can examine
the state of the hardware event by reading the status bit without generating an SCI interrupt.
Any status bit, unless otherwise noted, can only be set by some defined hardware event. It is cleared
by writing a 1 to its bit position; writing a 0 has no effect. Except forsome special status bits, every
status bit has an assiciated enable bit in the same bit position in the enable register. Those status bits
which have no respective enable bit are read for special purposes. Reserved or un-implemented
enable bits always return zero, and writing to these bits should have no effect.
相關PDF資料 |
PDF描述 |
|---|---|
| W83877TF | Multi-Function I/O Port Controller(用于個人計算機的多功能輸入/輸出口控制器) |
| W83971D | AC97 AUDIO CODEC |
| W83977AF | PLUG & PLAY 1.0A COMPLIANT |
| W83977EF | WINBOND I/O |
| W83977F | PLUG & PLAY 1.0A COMPLIANT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W83877TF | 制造商:WINBOND 制造商全稱:Winbond 功能描述:WINBOND I/O |
| W83877TG | 功能描述:IC I/O CONTROLLER 100-PQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 專用 系列:- 標準包裝:3,000 系列:- 應用:PDA，便攜式音頻/視頻，智能電話 接口:I²C，2 線串口 電源電壓:1.65 V ~ 3.6 V 封裝/外殼:24-WQFN 裸露焊盤 供應商設備封裝:24-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) 安裝類型:表面貼裝 產品目錄頁面:1015 (CN2011-ZH PDF) 其它名稱:296-25223-2 |
| W83910F | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:IPMI BMC plus H/W Monitor. UART. 5-sets Master/Slave SMBus. for Server PC Application |
| W83960G (REV. B) | 制造商:Nuvoton Technology Corp 功能描述:IC H/W MONITOR 64LQFP |
| W83971D | 制造商:WINBOND 制造商全稱:Winbond 功能描述:AC97 AUDIO CODEC |
發布緊急采購，3分鐘左右您將得到回復。