- 您現在的位置：買賣IC網 > PDF目錄373942 > AD830 (Analog Devices, Inc.) High Speed, Video Difference Amplifier(高速,視頻差分運放) PDF資料下載
參數資料
| 型號： | AD830 |
| 廠商： | Analog Devices, Inc. |
| 元件分類： | 運動控制電子 |
| 英文描述： | High Speed, Video Difference Amplifier(高速,視頻差分運放) |
| 中文描述： | 高速，視頻差分放大器（高速，視頻差分運放） |
| 文件頁數： | 8/16頁 |
| 文件大小： | 244K |
| 代理商： | AD830 |
AD830
REV. A
–8–
T RADIT IONAL DIFFE RE NT IAL AMPLIFICAT ION
In the past, when differential amplification was needed to reject
common-mode signals superimposed with a desired signal; most
often the solution used was the classic op amp based difference
amplifier shown in Figure 19. T he basic function V
O
= V
1
–V
2
is
simply achieved, but the overall performance is poor and the cir-
cuit possesses many serious problems that make it difficult to re-
alize a robust design with moderate to high levels of
performance.
R
1
R
2
R
3
R
4
V
OUT
V
2
V
1
ONLY IF R
1
= R
2
= R
3
= R
4
DOES
V
OUT
= V
1
– V
2
Figure 19. Op Amp Based Difference Amplifier
PROBLE MS WIT H T HE OP AMP BASE D APPROACH
Low Common-Mode Rejection Ratio (CMRR)
Low Impedance Inputs
CMRR Highly Sensitive to the Value of Source R
Different Input Impedance for the + and – Input
Poor High Frequency CMRR
Requires Very Highly Matched Resistors R
1
–R
4
to Achieve
High CMRR
Halves the Bandwidth of the Op Amp
High Power Dissipation in the Resistors for Large Common-
Mode Voltage
AD830 FOR DIFFE RE NT IAL AMPLIFICAT ION
T he AD830 amplifier was specifically developed to solve the
listed problems with the discrete difference amplifier approach.
Its topology, discussed in detail in a later section, by design acts
as a difference amplifier. T he circuit of Figure 20 shows how
simply the AD830 is configured to produce the difference of two
signals V
1
and V
2
, in which the applied differential signal is
exactly reproduced at the output relative to a separate output
common. Any common-mode voltage present at the input is
removed by the AD830.
A=1
V
→
I
V
→
I
V
OUT
V
2
V
1
V
OUT
= V
1
– V
2
I
Y
I
X
Figure 20. AD830 as a Difference Amplifier
ADVANT AGE OUS PROPE RT IE S OF T HE AD830
High Common-Mode Rejection Ratio (CMRR)
High Impedance Inputs
Symmetrical Dynamic Response for +1 and –1 Gain
Low Sensitivity to the Value of Source R
Equal Input Impedance for the + and – Input
Excellent High Frequency CMRR
No Halving of the Bandwidth
Constant Power Distortion vs. Common-Mode Voltage
Highly Matched Resistors Not Needed
相關PDF資料 |
PDF描述 |
|---|---|
| AD8313ARM-REEL7 | 0.1 GHz-2.5 GHz, 70 dB Logarithmic Detector/Controller |
| AD8313ARM | 0.1 GHz-2.5 GHz, 70 dB Logarithmic Detector/Controller |
| AD8313ARM-REEL | 0.1 GHz-2.5 GHz, 70 dB Logarithmic Detector/Controller |
| AD8313-EVAL | 0.1 GHz-2.5 GHz, 70 dB Logarithmic Detector/Controller |
| AD8313 | 0.1 GHz－2.5 GHz,70dB Logarithmic Detector/Controller(頻率為0.1 GHz－2.5 GHz,增益為70dB的對數檢測器/控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD830_10 | 制造商:AD 制造商全稱:Analog Devices 功能描述:High Speed, Video Difference Amplifier |
| AD8300 | 制造商:AD 制造商全稱:Analog Devices 功能描述:+3 Volt, Serial Input Complete 12-Bit DAC |
| AD8300AN | 功能描述:IC DAC 12-BIT SERIAL 8-DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率（每秒）:* |
| AD8300ANZ | 功能描述:IC DAC 12BIT SERIAL 8DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:1 系列:- 設置時間:4.5µs 位數:12 數據接口:串行，SPI? 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOICN 包裝:剪切帶 (CT) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:* 其它名稱:MCP4921T-E/SNCTMCP4921T-E/SNRCTMCP4921T-E/SNRCT-ND |
| AD8300AR | 功能描述:IC DAC 12BIT 3V SRL-IN 8-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:47 系列:- 設置時間:2µs 位數:14 數據接口:并聯 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:55µW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:管件 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:* |
發布緊急采購，3分鐘左右您將得到回復。