- 您現在的位置：買賣IC網 > PDF目錄363904 > W89C926 (WINBOND ELECTRONICS CORP) PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER PDF資料下載
參數資料
| 型號： | W89C926 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 英文描述： | PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| 中文描述： | PCMCIA以太網雙絞線網絡接口控制器 |
| 文件頁數： | 24/48頁 |
| 文件大小： | 395K |
| 代理商： | W89C926 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
W89C926 PENTIC+
- 24 -
BUS ARBITRATION AND STATE DIAGRAM
The PENTIC+ handles bus arbitration automatically. It can operate in four modes: idle state, slave
read/write mode, DMA mode, and shared memory mode. The PENTIC+ controls the on-board
devices by decoding these modes.
At power-on, the PENTIC+ is in idle mode. If a register read/write command is issued, the PENTIC+
enters the slave read/write mode. If a local DMA or remote DMA (I/O mode only) is initiated by the
PENTIC+ core coprocessor, the PENTIC+ enters DMA mode. A memory command will place the
PENTIC+ in memory mode. At any given time, the PENTIC+ can be in only one state. The PENTIC+
handles state changes automatically. However, two events, such as a DMA command and a memory
command, may be requested at the same time; in this case, the PENTIC+ allocates the bus on a first-
come, first-served basis. No predefined priority is set within the PENTIC+.
Power-on
Reset
Idle
Slave read/ write
DMA operation
Memory operation
Register
access
Core
Memory
access
access
In cases where the system has no authority on the requested bus, the PENTIC+ will drive the WAIT
pin low so that the system can insert wait states. After the PENTIC+ has released the bus authority,
WAIT is deasserted to instruct the system to stop inserting wait states.
SLCT CORE FUNCTION
The SLCT core coprocessor has five major logic blocks that control Ethernet operations: the register
files, transmit logic, receive logic, FIFO logic, and DMA logic. The relationship between these blocks
is depicted in the following block diagram.
PCMCIA
Slot
Interface
DMA
Interface
Logic
SNA
TX/RX
Logic
16-byte
FIFO
Transmit
Logic
Receive
Logic
Register
File
相關PDF資料 |
PDF描述 |
|---|---|
| W89C926F | 10M PCMCIA Ethernet Network Interface Controller |
| W89C940 | ELANC-PCI (TWISTED-PAIR ETHER-LAN CONTROLLER WITH PCI INTERFACE) |
| W89C982 | INTEGRATED MULTIPLE REPEATER II |
| W89C982AF | INTEGRATED MULTIPLE REPEATER II |
| W8NB80 | N - CHANNEL 800V - 1.2ohm - 7.5A - TO-247 PowerMESH MOSFET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W89C926F | 制造商:WINBOND 制造商全稱:Winbond 功能描述:10M PCMCIA Ethernet Network Interface Controller |
| W89C926PENTIC+ | 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| W89C92P | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10M CMOS Coaxial Transceiver |
| W89C940 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:ELANC-PCI (TWISTED-PAIR ETHER-LAN CONTROLLER WITH PCI INTERFACE) |
| W89C940F | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10M PCI-Bus Ethernet Network Interface Controller |
發布緊急采購，3分鐘左右您將得到回復。