- 您現在的位置：買賣IC網 > PDF目錄363910 > W99681CF (WINBOND ELECTRONICS CORP) JPEG USB Dual Mode Camera Chip(運用JPEG壓縮技術、通用串行總線結構技術、雙制式的照相電路數字處理芯片的攝像照相機接口控制器) PDF資料下載
參數資料
| 型號： | W99681CF |
| 廠商： | WINBOND ELECTRONICS CORP |
| 英文描述： | JPEG USB Dual Mode Camera Chip(運用JPEG壓縮技術、通用串行總線結構技術、雙制式的照相電路數字處理芯片的攝像照相機接口控制器) |
| 中文描述： | JPEG格式相機的USB雙模芯片（運用的JPEG壓縮技術，通用串行總線結構技術，雙制式的照相電路數字處理芯片的攝像照相機接口控制器） |
| 文件頁數： | 39/78頁 |
| 文件大小： | 816K |
| 代理商： | W99681CF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁當前第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁
W99681CF
Publication Release Date: March 2000
- 39 - Revision A1
7.8 Microcontroller Interface
The W99681CF supports an external 8-bit microcontroller to access DRAM and W99681CF internal
registers for portable PC camera applications.
7.8.1 Base Address Setup
The W99681CF internal registers occupy 256-byte microcontroller address space. A special base
address (BA) setup mechanism, described as followed, is designed for the microcontroller to configure
base address for the W99681CF internal register access:
1
assert hardware reset.
write the key,
″
!
″
!
″
″
W
″
″
9
″
″
9
″
″
6
″
″
7
″
″
!
″
in ASCII code, to the port xx00H.
the port address, xx00H, then will be used as Base Address (BA) for the microcontroller
access.
2
3
The setup procedure must be executed right after the hardware reset. Once the procedure is finished,
the xx00H address will be used as the base address until another hardware reset is asserted.
7.8.2 W99681CF Register Access
Since all internal registers are 16-bit wide, it takes two cycles for the microcontroller to access one 16-
bit register through the 8-bit data bus. The two microcontroller access cycles should be in low-byte then
high-byte order. For example, to write CR00 register, the microcontroller must write to BA + 00H
address at first, then write to BA + 01H address to complete this 16-bit register access.
7.8.3 Microcontroller Interrupt
The W99681CF interrupts the microcontroller by forcing INT# pin to low when it completes a still image
capture (original video mode) or JPEG compression of this image (JPEG compression mode). Once
interrupt is acknowledged by the microcontroller, it must write one to bit 5 of the Miscellaneous Control
register (CR00_5) to clear the interrupt. Interrupt can also be disabled by writing zero to bit 6 of the
Miscellaneous Control register (CR00_6).
7.8.4 DRAM Access
The external microcontroller can read/write access DRAM through W99681CF by using the following
registers:
uC Access DRAM Start Address Register (BA + 18H ~ 1AH): specifies the 21-bit starting
WORD address of the DRAM to be accessed.
uC Access DRAM Mode Select (bit 8 of BA + 1BH): specifies read or write access mode.
uC Access DRAM Data Port Register (BA + 1CH ~ 1DH): 16-bit data port which stores data
read from DRAM in read mode, or data to be written into DRAM in write mode.
Read Access (uC reads data from DRAM)
相關PDF資料 |
PDF描述 |
|---|---|
| W9971CF | Integrated Video Graphics Accelerator(集成的視頻圖形加速器) |
| W9980 | Digital Voice Recorder(數字式錄音器) |
| WA08-2433A | 820-980 MHz LOW NOISE BALANCE AMPLIFIER WA08-2433A |
| WA0805ML180A | Multilayer Ceramic Transient Voltage Suppressors for Automotive Applications |
| WA1206ML180A | Multilayer Ceramic Transient Voltage Suppressors for Automotive Applications |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W99685 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| W99685BS | 制造商:WINBOND 制造商全稱:Winbond 功能描述:SYSTEM CAMERA DEVICE |
| W99685FS | 制造商:WINBOND 制造商全稱:Winbond 功能描述:SYSTEM CAMERA DEVICE |
| W9968CF | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Digital Camera |
| W9986D | 制造商:WINBOND 制造商全稱:Winbond 功能描述:MPEG Audio Layer III Decoder |
發布緊急采購，3分鐘左右您將得到回復。