- 您現在的位置：買賣IC網 > PDF目錄98238 > TLC320AD80CPM (TEXAS INSTRUMENTS INC) SPECIALTY CONSUMER CIRCUIT, PQFP64 PDF資料下載
參數資料
| 型號： | TLC320AD80CPM |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 消費家電 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP64 |
| 封裝： | PLASTIC, TQFP-64 |
| 文件頁數： | 15/37頁 |
| 文件大小： | 229K |
| 代理商： | TLC320AD80CPM |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
2–11
2.5.3
Power-Down/Reset
When the RESET terminal is held low, the TLC320AD80C is put in a power-down condition. During power
down, the sigma-delta DACs are disabled to conserve power and the digital output drivers (ABCLK,
ALRCLK, and CDOUT) are placed in a high-impedance state. When powered down, the analog audio
outputs settle near Vref (2.25 V).
There are two ways in which to initialize the TLC320AD80C.
The TLC320AD80C begins reset and initialization on the rising edge of the RESET signal. A
stable clock waveform having a frequency within the specified allowable frequency range (see
Timing Requirements section) must be present at the master clock (MCLK1) input prior to the
rising edge of the RESET signal for proper operation. In order to prevent the occurrence of
audible pops or clicks from the TLC320AD80C, the RESET terminal must be kept low 500 ms
after the power supplies have settled. This provides adequate time for the 2.25-V based line
outputs to charge the large output capacitors on the analog audio outputs while minimizing any
audible pops.
Set bit D0 of control register 02h to 1.
To maximize the initialization cycle accuracy, the TLC320AD80C should not be continually polled. This
initialization cycle takes about 500 ms to complete following the rising edge of RESET.
The power-down mode can also be selected by setting bit D0 of control register 02h to 1. In this software
controlled power-down mode the sigma-delta DACs, the monaural decoder, and the audio input amplifiers
are all disabled to conserve power. The external audio outputs (EXT OUTR, EXT OUTL) are muted to hold
the output voltage at Vref. Since muting the external audio output can cause an audible click, a zero crossing
mute should be performed prior to initiating a software power-down.
2.6
Software Interface
Control of the TLC320AD80 is accomplished by means of the SPI serial interface and the control registers
described in Appendix A.
相關PDF資料 |
PDF描述 |
|---|---|
| TLC320AD81CDBTR | 2 CHANNEL(S), EQUALIZER CIRCUIT, PDSO38 |
| TLC320AD81CDBT | 2 CHANNEL(S), EQUALIZER CIRCUIT, PDSO38 |
| TLC320AD81EVM | 2 CHANNEL(S), EQUALIZER CIRCUIT, PDSO38 |
| TLC320AD90CPMR | SPECIALTY CONSUMER CIRCUIT, PQFP64 |
| TLC320AD90CPM | SPECIALTY CONSUMER CIRCUIT, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLC320AD81C | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Stereo Audio Digital Equalizer DC |
| TLC320AD81CDBT | 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel |
| TLC320AD90 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Stereo Audio Codec |
| TLC320AD91 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Stereo Audio Codec |
| TLC320AD91CPT | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。