- 您現在的位置：買賣IC網 > PDF目錄363894 > W742C813 (WINBOND ELECTRONICS CORP) 4-BIT SINGLE-CHIP MICROCONTROLLER FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTER PDF資料下載
參數資料
| 型號： | W742C813 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 4-BIT SINGLE-CHIP MICROCONTROLLER FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTER |
| 中文描述： | 4-BIT, MROM, 3.58 MHz, MICROCONTROLLER, PQFP100 |
| 封裝： | 14 X 20 MM, 2.75 MM HEIGHT, QFP-100 |
| 文件頁數： | 22/56頁 |
| 文件大小： | 455K |
| 代理商： | W742C813 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁
W742E/C813
- 22 -
5.12.3 Mode Register 0 (MR0)
Mode Register 0 is organized as a 4-bit binary register (MR0.0 to MR0.3). MR0 can be used to control
the operation of Timer 0. The bit descriptions are as follows:
0
1
2
3
Note: W means write only.
Bit 0 = 0 The fundamental frequency of Timer 0 is F
OSC
/4.
= 1 The fundamental frequency of Timer 0 is F
OSC
/1024.
Bit 1 & Bit 2 are reserved
Bit 3 = 0 Timer 0 stops down-counting.
= 1 Timer 0 starts down-counting.
W
W
MR0
5.12.4 Mode Register 1 (MR1)
Mode Register 1 is organized as a 4-bit binary register (MR1.0 to MR1.3). MR1 can be used to control
the operation of Timer 1. The bit descriptions are as follows:
Note: W means write only.
W
W
W
W
0
1
2
3
MR1
Bit 0 = 0 The internal fundamental frequency of Timer 1 is F
OSC
.
= 1 The internal fundamental frequency of Timer 1 is F
OSC
/64.
Bit 1 = 0 The fundamental frequency source of Timer1 is the internal clock.
= 0 The fundamental frequency source of Timer1 is the sub-oscillator frequency Fs
(32.768 KHz).
Bit 2 = 0 The specified waveform of the MFP generator is delivered at the MFP output pin.
= 1 The specified frequency of Timer 1 is delivered at the MFP output pin.
Bit 3 = 0 Timer 1 stops down-counting.
= 1 Timer 1 starts down-counting.
5.13 Interrupts
The W742E/C813 provides four internal interrupt sources (Divider 0, Divider 1, Timer 0, Timer 1) and
seven external interrupt source (port P1.2 (INT0 ), RC.0-3, Serial port, P1.3 (INT1)). Vector addresses
for each of the interrupts are located in the range of program memory (ROM) addresses 004H to
023H. The flags IEF, PEF, and EVF are used to control the interrupts. When EVF is set to "1" by
hardware and the corresponding bits of IEF and PEF have been set by software, an interrupt is
generated.
When an interrupt occurs, the corresponding bit of EVF will be clear, and all of the
interrupts will be inhibited until the EN INT or MOV IEF,#I instruction is invoked
.
Normally, the
EN INT instruction will be asserted before the RTN instruction
. The interrupts can also be disabled
相關PDF資料 |
PDF描述 |
|---|---|
| W742C814 | 4-BIT SINGLE-CHIP MICROCONTROLLER FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTER |
| W742E813 | 4-BIT MICROCONTROLLER |
| W742C81A | 4-BIT MICROCONTROLLER |
| W742S819 | 4-BIT TELEPHONE CONTROLLER |
| W742S81A | 4-BIT SINGLE-CHIP MICROCONTROLLER FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W742C814 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:4 BIT MICROCONTROLLER |
| W742C816 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller |
| W742C818 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller |
| W742C81A | 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT MICROCONTROLLER |
| W742CE811 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT MICROCONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。