- 您現在的位置：買賣IC網 > PDF目錄363904 > W89C92 (WINBOND ELECTRONICS CORP) PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER PDF資料下載
參數資料
| 型號： | W89C92 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 網絡接口 |
| 英文描述： | PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| 中文描述： | DATACOM, ETHERNET TRANSCEIVER, PDIP16 |
| 封裝： | DIP-16 |
| 文件頁數： | 14/48頁 |
| 文件大小： | 395K |
| 代理商： | W89C92 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
W89C926 PENTIC+
- 14 -
F/EE = 0 (EEPROM used)
SYSTEM
OFFSET (HA0-16)
MEMORY TYPE
NAME
00000H
003D6H
Attribute/
(Note)
CIS
(492x 8)
Notes:
1. This attribute memory is an image from EEPROM. It is physically resident in upper half of the SRAM after power-on auto-
loading.
2. Refer to "Attribute Memory Mapping" for detailed locations.
3. The PENTIC+ decodes HA0-16 for memory access. The (common or attribute) MEMBase addresses are left for the host adapter
and the socket service to determine.
REGISTER FILE
The W89C926 PENTIC+ has four register sets: the core register set, the PCMCIA configuration
register set, the LAN configuration register set, and the special control register set. The core register
set is the same as that in the W89C90 and will not be discussed here. The other three register sets
are described below.
PCMCIA Configuration Register Set
The PENTIC+ provides three PCMCIA configuration registers needed to ensure compatibility with
various operating systems.
COR (Configuration Option Register)
Access Address: AMBase + 00FD0H
Access Type: Attribute Memory Read/Write
BIT
0-5
SYMBOL
IDX0-5
DESCRIPTION
Configuration Index
These six bits are used to indicate entry of the card configuration table
located in the CIS (Card Information Structure; refer to PCMCIA R2.1).
These bits are 0 at power-on.
Reserved, must be 1 (level mode interrupt) when read.
S/W Reset
A software reset is issued when a 1 is written to this bit. This is the same
as a H/W reset except that this bit and the necessary information (CFA,
CFB, CIS, and Ethernet ID) are not cleared, and the auto-load procedure
is not performed. Returning a 0 to this bit will leave the PENTIC+ in a
post-reset state the same as that following a hardware reset. The value of
this bit at power-on is 0.
6
7
-
SRESET
相關PDF資料 |
PDF描述 |
|---|---|
| W89C926 | PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| W89C926F | 10M PCMCIA Ethernet Network Interface Controller |
| W89C940 | ELANC-PCI (TWISTED-PAIR ETHER-LAN CONTROLLER WITH PCI INTERFACE) |
| W89C982 | INTEGRATED MULTIPLE REPEATER II |
| W89C982AF | INTEGRATED MULTIPLE REPEATER II |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W89C926 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| W89C926F | 制造商:WINBOND 制造商全稱:Winbond 功能描述:10M PCMCIA Ethernet Network Interface Controller |
| W89C926PENTIC+ | 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| W89C92P | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10M CMOS Coaxial Transceiver |
| W89C940 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:ELANC-PCI (TWISTED-PAIR ETHER-LAN CONTROLLER WITH PCI INTERFACE) |
發布緊急采購，3分鐘左右您將得到回復。