- 您現在的位置：買賣IC網 > PDF目錄363904 > W89C92 (WINBOND ELECTRONICS CORP) PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER PDF資料下載
參數資料
| 型號： | W89C92 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 網絡接口 |
| 英文描述： | PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| 中文描述： | DATACOM, ETHERNET TRANSCEIVER, PDIP16 |
| 封裝： | DIP-16 |
| 文件頁數： | 21/48頁 |
| 文件大小： | 395K |
| 代理商： | W89C92 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
W89C926 PENTIC+
Publication Release Date: January 1996
- 21 -
Revision A1
The ADR register located at page3 04H of the core controller is used as a temporary register for
EEPROM read/write. When the EEPROM load-back sequence specified above is performed, the
content of the specified address will be overwritten by the new data. Note that since the EEPROM is
word-aligned, each time the sequence is performed one word of data is modified. The address range
available is from 00H to ffH. To make sure that the EEPROM is written correctly, the programmer can
use the following read-check process to read a word from a specified address in the EEPROM.
write (EEAR, EOS = 1 EW/ER = 0);
write (ADR, address);
wait ( );
repeat (
read(EEAR, EOS);
) until (EOS = 0);
read(ADR);
/* read word data */
/* The entire sequence should be consecutive or the process will be aborted. */
Note that data will be kept in the ADR until they are updated. That is, the data can be read out any
time afterwards unless new data have been written.
SRAM Physical Map
When an EEPROM is used for attribute memory storage, the 32K byte SRAM has two roles in the
PENTIC+ design: the first 16K bytes of SRAM serve as an Ethernet buffer ring, while the remainder is
used for temporary storage of Ethernet IDs and CIS storage (if EECS/FCS is pulled low). The
detailed physical mapping of the SRAM memory is shown in the table below. When a flash memory is
used, only a 16K byte SRAM is needed to serve as the Ethernet ring buffer.
SRAM Physical
Address
0000H-
3FFFH
4000H
4001H
4002H
4003H
4004H
4005H
4006H
4007H
4008H-
400DH
400EH
400FH
4010H-
41FBH
41FCH-
7FFFH
EECS/
FCS
pull low
EECS/
FCS
pull high
Ethernet
Buffer
ID0
ID1
ID2
ID3
ID4
ID5
Ethernet
Buffer
Board Type (05H)
Checksum
-
Unused
57H
57H
CIS
-
相關PDF資料 |
PDF描述 |
|---|---|
| W89C926 | PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| W89C926F | 10M PCMCIA Ethernet Network Interface Controller |
| W89C940 | ELANC-PCI (TWISTED-PAIR ETHER-LAN CONTROLLER WITH PCI INTERFACE) |
| W89C982 | INTEGRATED MULTIPLE REPEATER II |
| W89C982AF | INTEGRATED MULTIPLE REPEATER II |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W89C926 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| W89C926F | 制造商:WINBOND 制造商全稱:Winbond 功能描述:10M PCMCIA Ethernet Network Interface Controller |
| W89C926PENTIC+ | 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| W89C92P | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10M CMOS Coaxial Transceiver |
| W89C940 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:ELANC-PCI (TWISTED-PAIR ETHER-LAN CONTROLLER WITH PCI INTERFACE) |
發布緊急采購，3分鐘左右您將得到回復。