国产精品成人VA在线观看-国产乱妇乱子视频在播放-国产日韩精品一区二区三区在线-国模精品一区二区三区

參數資料
型號: W89C92
廠商: WINBOND ELECTRONICS CORP
元件分類: 網絡接口
英文描述: PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER
中文描述: DATACOM, ETHERNET TRANSCEIVER, PDIP16
封裝: DIP-16
文件頁數: 22/48頁
文件大小: 395K
代理商: W89C92
W89C926 PENTIC+
- 22 -
Note that if EECS/FCS is pulled low, the CIS is stored in the SRAM starting at address 4010H. The
length of the CIS depends on the word count specified in the first byte of EEPROM. During a power-
on reset, the PENTIC+ will load the exact word count specified in the EEPROM rather than read in all
bytes in the EEPROM.
The PENTIC+ will automatically translate the address from the host if the host tries to read CIS. It will
translate the attribute memory address by assuming that the first CIS byte is stored at 00H of attribute
memory, the second CIS byte is stored at 02H, and so forth. Users should assign CIS accordingly, or
else the CIS may be lost.
Also note that for auto-load information write protection, the PENTIC+ will ignore any write operation
above 4000H of SRAM. If it is necessary to change the settings, users should do so by writing the
flash memory or EEPROM.
Minimal System Design
A low-cost, dedicated LAN card can be designed using the PENTIC+ chip, a 32K x 8 SRAM, a serial
EEPROM (93C66/93CS66), and a pig tail for the network interface MAU, along with certain other
peripheral components. The following is a sample CIS table that can be used with this minimal
system design:
01 03 dc 03 ff
17 03 5b 09 ff
1a 05 01 01 e0 1f 0f
1b 13 c1 c1 7d 19 55 15 26 00 33 43 16 45 70 ff ff 48 40 00 00
14 00
f0 09 'WinICard' ff
21 02 06 03
20 04 u00 u01 u02 u03
15 14 04 01 u04 u05 u06 u07 u08 u09 u10 u11 u12 u13 u14 u15 u16 u17 u18 u19 00 ff
ff ff
FLASH MEMORY ACCESS
The flash access and the buffer SRAM share the same memory support bus. The address pins of the
flash memory are directly connected to MSA bus and data are accessed through the MSD bus.
EECS/FCS is active low if it is pulled high and the attribute memory is accessed in the range 00000H
to 03FFFH or the common memory is accessed in the range 04000H to 1FFFFH. Note that
CFB.FWE should be set to 1 before a flash write command is issued.
I/O MODE OPERATION
The I/O mode provides two DMA channels for system access. The remote DMA moves data between
system memory space and local memory space. The local DMA moves data between the FIFO of the
SLCT and local memory space. However, since the SLCT can handle local DMA operations
without system intervention (refer to the data sheet for the SLCT), the system has to perform only re-
mote DMA reads/writes.
In a transmit operation, the data should first be moved from the system to local buffer memory. This
is simply an "OUT" command on the PC. Then the system orders the SLCT to start transmission, and
the local DMA starts to move data from buffer memory to the transmit FIFO for transmission.
In a receive operation, the local DMA moves received data from the receive FIFO to the buffer and
asserts IREQ to the system when the buffer ring needs to be serviced. The system must move data
相關PDF資料
PDF描述
W89C926 PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER
W89C926F 10M PCMCIA Ethernet Network Interface Controller
W89C940 ELANC-PCI (TWISTED-PAIR ETHER-LAN CONTROLLER WITH PCI INTERFACE)
W89C982 INTEGRATED MULTIPLE REPEATER II
W89C982AF INTEGRATED MULTIPLE REPEATER II
相關代理商/技術參數
參數描述
W89C926 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER
W89C926F 制造商:WINBOND 制造商全稱:Winbond 功能描述:10M PCMCIA Ethernet Network Interface Controller
W89C926PENTIC+ 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER
W89C92P 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10M CMOS Coaxial Transceiver
W89C940 制造商:WINBOND 制造商全稱:Winbond 功能描述:ELANC-PCI (TWISTED-PAIR ETHER-LAN CONTROLLER WITH PCI INTERFACE)