- 您現在的位置：買賣IC網 > PDF目錄156639 > 24IMS6-12-9Z (POWER-ONE INC) 1-OUTPUT 6 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | 24IMS6-12-9Z |
| 廠商： | POWER-ONE INC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 6 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | DIP-24 |
| 文件頁數： | 7/10頁 |
| 文件大小： | 630K |
| 代理商： | 24IMS6-12-9Z |
IMS6 Series: 6W DC-DC Converters
Product Specifications
18-36V & 36-75V Inputs
May 2002
Single and Dual outputs 5V, 12V & 15V
May 31, 2002
Rev 1.1
Page 6 of 10
www.power-one.com
Output overvoltage protection
The outputs of the IMS6 converters are protected against
overvoltages by Zener diodes. In the event of an overvolt-
age on the output, the unit will shut-down and attempt to
restart automatically. The main purpose of this feature is to
protect against possible overvoltages which could occur
due to a failure in the feedback control circuit. The units are
not designed to withstand external overvoltages applied to
the outputs.
Connection in series
The outputs of single or dual output units can be connected
in series without any precautions, taking into consideration
that the highest output voltage should remain below 60V
for SELV operation.
Connection in parallel
The outputs of several units with equal nominal output volt-
age can be connected in parallel. Approximate current
sharing between 2 or several units is ensured by their load
dependent output characteristic.
Short Circuit Behaviour
The current limit characteristic shuts down the converter
whenever a short circuit is applied to its output. It acts self-
protecting and automatically recovers after removal of the
overload condition.
Fig. 8
Uo versus Io (typ) of single output units
(example for 48IMS6-05-9)
Fig. 9
Uo versus Io (typ) of dual output units (±15 V), with 30 V
load connected to Vo+ and Vo–.
5.25
5.0
4.75
4.5
4.25
4.0
0
0.1
0.2 0.3 0.4
0.6
0.8 1.0 1.2
1.4 1.6 I
o [A]
Uo [V]
05056
28.5
29
29.5
30
30.5
31
31.5
Uo1 + Uo2 [V]
20
40
60
80
120
160
200
Io [mA]
0
05057
14
14.5
15
15.5
16
16.5
Uo1 [V]
20
40
60
80
120
160
200 Io1 [mA]
0
Io2 = 200 mA
Io2 = 20 mA
05058
Uo1, Uo2 [V]
Io1
Io1 no
05059
12.8
12.4
12
11.6
11.2
030
60
90
120
150
[%]
Uo2
Uo1
Thermal Considerations
If a converter, mounted on a PCB, is located in free, quasi-
stationary air (convection cooling) at the indicated maxi-
mum ambient temperature TA max (see table: Temperature
specifications) and is operated at its nominal input voltage
and output power, the case temperature TC measured at
the: Measuring point of case temperature TC (see: Me-
chanical Data) will approach the indicated value TC max af-
ter the warm-up phase. However, the relationship between
TA and TC depends heavily on the conditions of operation
and integration into a system. The thermal conditions are
influenced by input voltage, output current, airflow, tem-
perature of surrounding components and surfaces and the
properties of the printed circuit board. TA max is therefore
only an indicative value and under practical operating con-
ditions, the ambient temperature TA may be higher or lower
than this value.
Caution: The case temperature TC measured at the
Measuring point of case temperature TC (see: Mechani-
cal Data) may under no circumstances exceed the speci-
fied maximum value. The installer must ensure that un-
der all operating conditions TC remains within the limits
stated in the table: Temperature specifications.
Typical Performance Curves
Fig. 10
Cross load regulation of dual output units. Uo1 versus
Io1 (typ) for various Io2 (48IMS6-1515-9).
Fig. 11
Flexible load distribution on dual outputs (2 x 12 V) with
load variation from 0...150% of Po1 nom on output 1.
Output 2 loaded with 25% of Po2 nom.
相關PDF資料 |
PDF描述 |
|---|---|
| 48IPD6-05-12-S | 2-OUTPUT 6 W DC-DC REG PWR SUPPLY MODULE |
| 48S3.15HE-N | 1-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE |
| 24S12.6HE | 1-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE |
| 24S12.6HE-N | 1-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE |
| 49-59111 | PUSHBUTTON SWITCH, SPST, MOMENTARY, 0.4A, 32VDC, PANEL MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 24IMS6-1515-9 | 功能描述:DC/DC轉換器 6W (2x 15V) DC Input (14-36V) RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| 24IMS6-15-9 | 制造商:POWER-ONE 制造商全稱:Power-One 功能描述:6 Watt SMD and through hole DC/DC converters |
| 24IMS7-03-9 | 制造商:POWER-ONE 制造商全稱:Power-One 功能描述:7 Watt DC-DC Converters |
| 24IMS7-05-05-7 | 制造商:Power-One 功能描述:- Bulk |
| 24IMS7-05-05-9 | 功能描述:DC/DC轉換器 7W (2x 5V) DC Input (14-36V) RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。