国产精品成人VA在线观看-国产乱妇乱子视频在播放-国产日韩精品一区二区三区在线-国模精品一区二区三区

參數資料
型號: W65C816S
廠商: Electronic Theatre Controls, Inc.
英文描述: Microprocessor
中文描述: 微處理器
文件頁數: 17/62頁
文件大小: 1129K
代理商: W65C816S
The Western Design Center, Inc.
W65C816S Data Sheet
The Western Design Center
W65C816S
17
The Data/Bank Address Bus (D0-D7) pins provide both the Bank Address and Data. The bank address is present
during the first half of a memory cycle, and the data value is read or written during the second half of the memory
cycle. Two memory cycles are required to transfer 16-bit values. These lines may be set to the high impedance
state by the Bus Enable (BE) signal.
3.5 Emulation Status (E)
The Emulation Status (E) output reflects the state of the Emulation (E) mode flag in the Processor Status (P)
Register. This signal may be thought of as an OpCode extension and used for memory and system management.
3.6 Interrupt Request (IRQB)
The Interrupt Request (IRQB) negative level active input signal is used to request that an interrupt sequence be
initiated. When the IRQB Disable (I) flag is cleared, a low input logic level initiates an interrupt sequence after
the current instruction is completed. The Wait-for-Interrupt (WAI) instruction may be executed to ensure the
interrupt will be recognized immediately. The Interrupt Request vector address is 00FFFE,F (Emulation mode) or
00FFEE,F (Native mode). Since IRQB is a level-sensitive input, an interrupt will occur if the interrupt source was
not cleared since the last interrupt. Also, no interrupt will occur if the interrupt source is cleared prior to interrupt
recognition. The IRQB signal going low causes 4 bytes of information to be pushed onto the stack before jumping
to the interrupt handler. The first byte is PBR followed by PCH, PCL and P (Processor Status Register). These
register values are used by the RTI instruction to return the processor to its original state prior to handling the IRQ
interrupt (see Table 6-1)
3.7 Memory Lock (MLB)
The Memory Lock (MLB) active low output may be used to ensure the integrity of Read-Modify-Write
instructions in a multiprocessor system. Memory Lock indicates the need to defer arbitration of the next bus cycle.
Memory Lock is low during the last three or five cycles of ASL, DEC, INC, LSR, ROL, ROR, TRB, and TSB
memory referencing instructions, depending on the state of the M flag.
3.8 Memory/Index Select Status (MX)
The Memory/Index Select Status (MX) multiplexed output reflects the state of the Accumulator (M) and Index (X)
elect flags (bits 5 and 4 of the Processor Status (P) Register. Flag M is valid during PHI2 negative transition and
Flag X is valid during PHI2 positive transition. These bits may be thought of as OpCode extensions and may be
used for memory and system management.
相關PDF資料
PDF描述
W6612 Dual PCM Codec(雙通道PCM編解碼器)
W6630CR Stereo Audio DAC(立體聲D/A轉換器)
W6631CS Stereo Audio DAC(立體聲音頻數模轉換器)
W6631 STEREO AUDIO DAC
W6662CF CCD(Correlated Double Sampler)/CIS(Contact Image Sensors) Analog Front End Signal Processor.(耦合采樣器/接觸圖象傳感器模擬前端信號處理器)
相關代理商/技術參數
參數描述
W65C816S6PG-14 功能描述:微處理器 - MPU 8/16-bit Microprocessor RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
W65C816S6PLG-14 功能描述:微處理器 - MPU 8/16-bit Microprocessor RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
W65C816S8P-14 制造商:未知廠家 制造商全稱:未知廠家 功能描述:16-Bit Microprocessor
W65C816S8PL-14 制造商:未知廠家 制造商全稱:未知廠家 功能描述:16-Bit Microprocessor
W65C816S8Q-14 制造商:未知廠家 制造商全稱:未知廠家 功能描述:16-Bit Microprocessor