- 您現在的位置：買賣IC網 > PDF目錄363904 > W89C841F (WINBOND ELECTRONICS CORP) 3-IN - 1 10/100M FAST ETHERNET CONTROLLER PDF資料下載
參數資料
| 型號： | W89C841F |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 3-IN - 1 10/100M FAST ETHERNET CONTROLLER |
| 中文描述： | 2 CHANNEL(S), 100M bps, LOCAL AREA NETWORK CONTROLLER, PQFP128 |
| 封裝： | 14 X 20 X 2.75 MM, QFP-128 |
| 文件頁數： | 26/102頁 |
| 文件大小： | 1154K |
| 代理商： | W89C841F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁
W89C841F/D
- 26 -
W89C840F transmit DMA function performs the data transfer from the host memory through on-chip
PCI bus master into the internal 2 Kbytes transmit FIFO. The transmit DMA state machine will request
the MAC to send out the data in the TX FIFO onto the transmission media.
Media Access Control (MAC) Function
The MAC function of W89C841F fully meets the requirements defined by the IEEE802.3u
specification. MAC performs many transmission functions, including the inter-frame spacing function,
collision detection, collision enforcement, collision backoff and retransmission. MAC performs the
receive functions including the address recognition function, the frame check sequence validation, the
frame disassembly, framing and collision filtering.
Full Duplex and Half Duplex Function
In the half duplex mode, the MAC should perform the transmission or reception operation at the
different time frame. Simultaneous transmission and reception is not allowed. However, in the time
duration from 10 bits time to 16 bits time after the packet is transmitted, the active COL signal is
recognized as a SQE test signal but not a collision event. The active signal CRS will be recognized as
a loopback carrier sense signal when the MAC is transmitting a packet. The carrier sense lost status is
relied on the CRS. Normally, there should not be any carrier sense lost during transmitting if the media
and devices are functional. In the full duplex mode, the MAC can perform the transmission and receive
operation at the same time. Collision event, SQE lost and carrier sense lost are not defined in the full
duplex mode. After auto-negotiation completed, network duplex mode can be decided by internal
PHYceiver.
Network Media Speed Function
W89C841F can work at network speed of 100M or 10Mbps. After auto-negotiation completed, network
speed can be decided by internal PHYceiver.
Flow Control in Full Duplex Mode
W89C841F supports asymmetrical and symmetrical flow control in full duplex mode compliant with
IEEE802.3x. After auto-negotiation completed, W89C841F will decide to operate in which flow control
mode (symmetrical, asymmetrical or none).
When the receiving byte counts of RX FIFO is over the high threshold defined at field HTV of register
Ddc/DRFCTV[17:9], a pause frame with MAX pause time (FFFFh) is transmitted to prevent the other
station keeping on transmitting packets to W89C841F. So W89C841F will not drop packets due to RX
FIFO overflow. When the receiving byte count of RX FIFO is below the low threshold defined at field
LTV of register Ddc/DRFCTV[8:0], a pause frame with MIN pause time (0000h) is transmitted to let the
other station starting to transmit packets to W89C841F.
If W89C841F receives a pause packet with non-zero pause time, the packet transmission ability will be
inhibited until the pause time counts down to 0. Pause frame is a flow control packet. It is not a data
packet and will be dropped by W89C841F.
Priority Tagged Frame Supporting QOS
A priority tagged frame defined at IEEE 802.1p contains a VLAN tag which indicates the user priority
and Null VLAN ID (VID = 0). W89C841F can transmit and receive priority tagged frames to improve the
network quality of service if bit VLANEN of register C1c/CNCR is set.
相關PDF資料 |
PDF描述 |
|---|---|
| W89C880F | 100Base-Tx/T4 Multiport Repeater Controller(100Base-Tx/T4多端口中繼器控制器) |
| W89C92 | PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| W89C926 | PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| W89C926F | 10M PCMCIA Ethernet Network Interface Controller |
| W89C940 | ELANC-PCI (TWISTED-PAIR ETHER-LAN CONTROLLER WITH PCI INTERFACE) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W89C841F/D | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:3-IN-1 100BASE-TX/FX & 10BASE-T Ethernet Controller |
| W89C880F | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LAN Hub Controller |
| W89C92 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| W89C926 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER |
| W89C926F | 制造商:WINBOND 制造商全稱:Winbond 功能描述:10M PCMCIA Ethernet Network Interface Controller |
發布緊急采購，3分鐘左右您將得到回復。