国产精品成人VA在线观看-国产乱妇乱子视频在播放-国产日韩精品一区二区三区在线-国模精品一区二区三区

參數資料
型號: W89C841F
廠商: WINBOND ELECTRONICS CORP
元件分類: 微控制器/微處理器
英文描述: 3-IN - 1 10/100M FAST ETHERNET CONTROLLER
中文描述: 2 CHANNEL(S), 100M bps, LOCAL AREA NETWORK CONTROLLER, PQFP128
封裝: 14 X 20 X 2.75 MM, QFP-128
文件頁數: 33/102頁
文件大?。?/td> 1154K
代理商: W89C841F
W89C841F/D
Publication Release Date: October 18, 2001
- 33 -
Revision A3
In CardBus system, Cxx and Dxx registers can be mapped to either system I/O space or memory
space. But CIS data can be mapped to memory space only. The following table lists the relative
mapping address in double word.
I/O SPACE ADDRESS
00h
3Ch
MEMORY SPACE ADDRESS
000h
03Ch
080h
0FCh
100h
1FCh
Cxx Register
CIS Data
X
Dxx Register
00h
FFh
W89C841F uses only one interrupt pin INTAB. However, the interrupt line resource assignment is
determined by the system BIOS by writing the related data into the bits ILINE of register F3C/FIR[7:0].
Power Management Function
W89C841F supports power management function that is compliant with ACPI R1.0, PCI power
management R1.1 and Network Device Class Power management Reference specification V1.0a.
Power management state from D0, D1, D3(hot) is provided by W89C841F. But whether the D3(cold)
power management state is provided is dependent on the auxiliary power detected or not after power
on reset. Power management D2 is not supported by W89C841F.
PME context consists of the bit PME_EN of register Fe0/FPMR1[8] and bit PME_STS of register
Fe0/FPMR1[15]. If D3(cold) power management state is supported, PME context will be kept valid.
When PMEB is asserted, it must continue to drive the signal low until software explicitly either clears
the PME Status bit or clears the PME Enable bit.
Wake-On-LAN Function
If the power management function is enabled, 3 types of wake-up events can be accepted by
W89c841F to acknowledge driver that wake-up event has happened. These wake-up events are
defined as:
Link status changed
Magic Packet
Wake-up frame
8. CONFIGURATION REGISTERS
The general attributes of the PCI configuration registers implemented in W89C841F are described as
the following.
1) Writes to the reserved configuration registers are treated as no-op. The bus access will complete
without affecting any data in W89C841F internal registers.
2) Read from the reserved or un-implemented registers will be returned 0
value.
3) SoftReset has no effect on the PCI configuration registers.
4) HardReset will clear the PCI configuration registers.
5) The implemented configuration registers support any byte enable combination access.
相關PDF資料
PDF描述
W89C880F 100Base-Tx/T4 Multiport Repeater Controller(100Base-Tx/T4多端口中繼器控制器)
W89C92 PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER
W89C926 PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER
W89C926F 10M PCMCIA Ethernet Network Interface Controller
W89C940 ELANC-PCI (TWISTED-PAIR ETHER-LAN CONTROLLER WITH PCI INTERFACE)
相關代理商/技術參數
參數描述
W89C841F/D 制造商:未知廠家 制造商全稱:未知廠家 功能描述:3-IN-1 100BASE-TX/FX & 10BASE-T Ethernet Controller
W89C880F 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LAN Hub Controller
W89C92 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER
W89C926 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCMCIA ETHERNET NETWORK TWISTED PAIR INTERFACE CONTROLLER
W89C926F 制造商:WINBOND 制造商全稱:Winbond 功能描述:10M PCMCIA Ethernet Network Interface Controller