- 您現在的位置：買賣IC網 > PDF目錄363900 > W79E225APG (WINBOND ELECTRONICS CORP) 8-BIT MICROCONTROLLER PDF資料下載
參數資料
| 型號： | W79E225APG |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT MICROCONTROLLER |
| 中文描述： | 8-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQCC44 |
| 封裝： | ROHS COMPLIANT, PLASTIC, LCC-44 |
| 文件頁數： | 96/200頁 |
| 文件大小： | 3644K |
| 代理商： | W79E225APG |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁當前第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁
Preliminary W79E225A/227A Data Sheet
Publication Release Date: December 14, 2007
- 96 -
Revision A2.0
12. PROGRAMMABLE TIMERS/COUNTERS
The W79E225/227 has three 16-bit programmable timer/counters.
12.1 Timer/Counters 0 & 1
TM0 and TM1 are 16-bit Timer/Counters, and there are nearly identical. Each of these Timer/Counters
has two 8 bit registers which form the 16 bits counting register. For Timer/Counter 0, it consists of
TH0, the upper 8 bits register, and TL0, the lower 8 bit register. Similarly Timer/Counter 1 has two 8
bits registers; TH1 and TL1. The two timers can be configured to operate either as timers, counting
machine cycles or as counters counting external inputs.
When configured as a "Timer", the timer counts clock cycles. In "Counter" mode, the register is
incremented on the falling edge of the corresponding external input pins, T0 for Timer 0 and T1 for
Timer 1. The T0 and T1 inputs are sampled in every machine cycle at C4. If the sampled value is high
in one machine cycle and low in the next, then a valid high to low transition on the pin is recognized
and the count register is incremented. Since it takes two machine cycles to recognize a negative
transition on the pin, therefore the maximum counting rate is 1/8 of the master clock frequency. In both
"Timer" and "Counter" mode, the count register is updated at C3. Therefore, in the "Timer" mode, the
recognized negative transition on pin T0 and T1 can cause the count register value to be updated only
in the machine cycle following the one in which the negative edge was detected.
The "Timer" or "Counter" function is selected by the "
Each Timer/Counter has one selection bit for its own; bit 2 of TMOD selects the function for
Timer/Counter 0 and bit 6 of TMOD selects the function for Timer/Counter 1. In addition each
Timer/Counter can be set to operate in any one of four possible modes. The mode selection is done
by bits M0 and M1 in the TMOD SFR.
T
C/
" bit in the TMOD Special Function Register.
12.1.1 Time-Base Selection
The W79E225/227 can operate like the standard 8051/52 family, counting at the rate of 1/12 of the
clock speed, or in turbo mode, counting at the rate of 1/4 clock speed. The speed is controlled by the
T0M and T1M bits in CKCON, and the default value is zero, which uses the standard 8051/52 speed.
12.1.2 Mode 0
In Mode 0, the timer/counter is a 13-bit counter. The 13-bit counter consists of THx (8 MSB) and the
five lower bits of TLx (5 LSB). The upper three bits of TLx are ignored. The timer/counter is enabled
when TRx is set and either GATE is 0 or
INTx
is 1. When
cycles; when
T
C/
is 1, it counts falling edges on T0 (P3.4 for Timer 0) or T1 (P3.5 for Timer 1). For
clock cycles, the time base may be 1/12 or 1/4 clock speed, and the falling edge of the clock
increments the counter. When the 13-bit value moves from 1FFFh to 0000h, the timer overflow flag
TFx is set, and an interrupt occurs if enabled. This is illustrated in next figure below.
T
C/
is 0, the timer/counter counts clock
相關PDF資料 |
PDF描述 |
|---|---|
| W79E227A | 8-BIT MICROCONTROLLER |
| W79E227AFG | 8-BIT MICROCONTROLLER |
| W79E227APG | 8-BIT MICROCONTROLLER |
| W79E532 | 8-BIT MICROCONTROLLER |
| W79E532A40DL | 8-BIT MICROCONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W79E226AFG | 制造商:WINBOND 制造商全稱:Winbond 功能描述:8-bit Microcontroller |
| W79E226ALG | 制造商:Nuvoton Technology Corp 功能描述:IC MCU 32K EPROM FLASH 48LQFP |
| W79E226APG | 制造商:Nuvoton Technology Corp 功能描述:IC MCU 32K EPROM FLASH 44PLCC |
| W79E227A | 制造商:WINBOND 制造商全稱:Winbond 功能描述:8-bit Microcontroller |
| W79E227AFG | 制造商:WINBOND 制造商全稱:Winbond 功能描述:8-bit Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。