- 您現在的位置：買賣IC網 > PDF目錄363904 > W88227F (WINBOND ELECTRONICS CORP) ATAPI CD-ROM Decoder(支持ATAPI標準的CD-ROM解碼器) PDF資料下載
參數資料
| 型號： | W88227F |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 消費家電 |
| 英文描述： | ATAPI CD-ROM Decoder(支持ATAPI標準的CD-ROM解碼器) |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP128 |
| 封裝： | PLASTIC, QFP-128 |
| 文件頁數： | 41/116頁 |
| 文件大小： | 787K |
| 代理商： | W88227F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁當前第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁
Preliminary/Confidential
Subject to change without notice
W88227F/W88227QD
- 37 -
1999/10/1 Rev: 0.70
IR - Index Register
The Decoder Index Register is latched from uP Port-0 by the buillt-in 74373 at the falling edge of internal
ALE
signal. The high byte address of decoder register is defined by
CCSA0 (40h)
with default value 40h.
<example>: decoder register read (read VER)
MOV
DPTR,#0401Ah
MOVX A,@DPTR
<example>: decoder register write (set CCSA1 as 0xC0h)
MOV
A,#0C0h
MOV
DPTR,#04041h
MOVX @DPTR,A
PFAR - Packet FIFO Access Register - (read 00h)
While
SCoD (20h.2)
is high, the ATAPI Command Packet issued from host is received by the 12-byte Packet
FIFO. Flag
TENDb (01h.r6)
and
FPKT (30h.r1)
are used to check if the Packet FIFO is full. The
microprocessor can read the ATAPI Command Packet by repeatedly read register
PFAR (00h,r)
. Once the
FIFO becomes empty, the value FFh will be returned if microprocessor read PFAR.
The Packet FIFO can also be used to receive command parameter less than 12 bytes. First, the control bit
SCoD (20h.2)
is set high to select the Packet FIFO to be addressed by the ATAPI Data port. When
DRQ
(37h.3)
changes from 0 to 1, the lower 4 bits of
ATBLO (34h)
is latched as the FIFO threshold. Upon the
number of bytes in the FIFO reaches the threshold, flag
TENDb (01h.r6)
becomes active-low and flag
FPKT
(30h.r1)
becomes active-high. Once
FPKT
becomes high, any data writes to the ATAPI Data port is rejected.
INTCTL - Interrupt Control Register - (write 01h, read 11h)
Bit 7:
PFNEEN - Packet FIFO Not Empty Interrupt Enable
If this bit is high, decoder interrupt activates when
PFNEb (01h.r7)
becomes active-low. This bit is
clear to 0 after master reset, firmware reset.
Bit 6:
TENDEN - Transfer End Interrupt Enable
If this bit is high, decoder interrupt activates when
TENDb (01h.r6)
becomes active-low. This bit is
also automatically enabled if the host issues the PACKET Command (opcode A0h) while
HIIEN
(2Eh.w7)
is high and drive is selected. This bit is clear to 0 after master reset, firmware reset.
SRIEN - Sector Ready Interrupt Enable
Bit 5:
If this bit is high, decoder interrupt activates when
SRIb (01h.r5)
becomes active-low. This bit is clear
to 0 after master reset, firmware reset and decoder reset.
Bit 4:
reserved
相關PDF資料 |
PDF描述 |
|---|---|
| W88227QD | ATAPI CD-ROM Decoder(支持ATAPI標準的CD-ROM解碼器) |
| W88611P | VCD 4X RF Amplifer/Digital Servo & DSP(具有射頻運算放大器及數字信號伺服和處理的集成芯片) |
| W88631F | VCD 4X RF Amplifer/Digital Servo & DSP(具有射頻運算放大器及數字信號伺服和處理的集成芯片) |
| W89C840AF | 100/10Mbps Ethernet Controller |
| W89C841F | 3-IN - 1 10/100M FAST ETHERNET CONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W88611P | 制造商:WINBOND 制造商全稱:Winbond 功能描述:VCD 4X RF AMP/DIGITAL SERVO & DSP |
| W88631F | 制造商:WINBOND 制造商全稱:Winbond 功能描述:VCD 4X RF AMP/DIGITAL SERVO & DSP |
| W88980 | 制造商:Performance Tool 功能描述:Anti-Fatigue Floor Mat Roll - 12 Square Feet 制造商:PERFORMANCE TOOLS 功能描述:ANTI-FATIGUE FLOOR MAT ROLL 12 SQ FT |
| W88981 | 制造商:Performance Tool 功能描述:Anti-Fatigue Floor Mat Roll - 32 Square Feet 制造商:PERFORMANCE TOOLS 功能描述:ANTI-FATIGUE FLOOR MAT ROLL 32 SQ FT |
| W88ACPX-1 | 制造商:Struthers-Dunn 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。