
W741E260
- 2 -
GENERAL DESCRIPTION
The W741E260 is a high-performance 4-bit microcontroller (
μ
C) that provides an LCD driver and the
flash EEPROM for the program memory. The device contains a 4-bit ALU, two 8-bit timers, two
dividers (for two oscillators) in dual-clock operation, a 32
×
4 LCD driver, and five 4-bit I/O ports
(including 1 output port for LED driving). There are also five interrupt sources and 8-level subroutine
nesting for interrupt applications. The W741E260 operates on very low current and has three power
reduction modes, hold mode and stop mode in single-clock operation and the dual-clock slow
operation, which help to minimize power dissipation.
This chip is available for W741C250 and W741C260 bodies, which can be selected by option code.
The W741E260 is suitable for end product manufacturer engineering testing and earlier samples
before mass production.
FEATURES
Operating voltage: 2.4V to 5.5V (LCD drive voltage: 3.0V, or 4.5V)
Crystal/Ceramic oscillator: up to 4 MHz
RC oscillator: up to 4 MHz
Dual-clock operation is selected by code option
Main oscillator
Crystal or RC oscillation circuit can be selected by code option
In crystal mode, high-frequency (400 KHz to 4 MHz) or low-frequency (32.768 KHz) oscillation
should be selected by code option
In RC mode, attention must be paid to the high/low frequency oscillation option, because the LCD
driver frequency and the ROM code emulation time are related to this option.
Sub-oscillator
Connect to 32768 Hz crystal only
Used in dual-clock operation
Memory
2048 x 16-bit program flash EEPROM (including 2K x 4-bit look-up table)
128 x 4-bit data RAM (including 16 working registers)
32 x 4 LCD data RAM
21 input/output pins
Ports for input only: 2 ports/8 pins
Input/output ports: 2 ports/8 pins
High sink current for LED driving: 1 port/4 pins
MFP output pin: 1 pin (MFP)
Power-down mode
Hold function: no operation (excluding main oscillator and sub-oscillator)
Stop function: no operation (excluding sub-oscillator)