- 您現在的位置：買賣IC網 > PDF目錄363893 > W66910CD (WINBOND ELECTRONICS CORP) TE Mode ISDN S/T-Controller with Microprocessor Interface PDF資料下載
參數資料
| 型號： | W66910CD |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 通信及網絡 |
| 英文描述： | TE Mode ISDN S/T-Controller with Microprocessor Interface |
| 中文描述： | SPECIALTY TELECOM CIRCUIT, PQFP100 |
| 封裝： | 14 X 20 MM, 1.40 MM HEIGHT, QFP-100 |
| 文件頁數： | 50/81頁 |
| 文件大小： | 681K |
| 代理商： | W66910CD |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁當前第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁
Data Sheet
W66910 PCI ISDN S/T-Controller
Address 0AH
Publication Release Date:
Feb,2001
Revision 1.0
-50 -
8.1.11 D_ch Receive Status Register
Value after reset: 20H
7
6
0
RDOV
CRCE
RDOV Receive Data Overflow
A "1" indicates that the D_RFIFO is overflow. The incoming data will overwrite data in the receive FIFO. The data overflow
condition will set both the status and interrupt bits. It is recommended that software must read the RDOV bit after reading data
from D_RFIFO at RMR or RME interrupt. The software must abort the data and issue a RRST command to reset the receiver if
RDOV = 1. The frame overflow condition will not set this bit.
CRCE CRC Error
This bit indicates the result of frame CRC check:
0: CRC correct
1: CRC error
RMB Receive Message Aborted
A "1" means that a sequence of seven 1's was received and the frame is aborted. Software must issue RRST command to reset the
receiver.
Note
: Normally D_RSTA register should be read by the microprocessor after a D_RME interrupt. The contents of D_RSTA are
valid only after a D_RME interrupt and remain valid until the frame is acknowledged via a RACK bit.
D_RSTA
Read
5
4
3
0
2
0
1
0
0
0
RMB
8.1.12 D_ch SAPI Address Mask
Value after reset: 00H
7
6
SAM7
SAM6
This register masks(disables) the first byte address comparison of the incoming frame. If the mask bit is "1" the corresponding bit
comparisons with D_SAP1, D_SAP2 are disabled. Comparison with SAPG is always performed.
Note
: For the LAPD frame, the least significant two bits are the C/R bit and EA =0 bit. It is suggested that the comparison with
C/R bit be masked. EA=0 for two octet address frame e.g LAPD, EA=1 for one octet address frame.
D_SAM
Read/Write Address 0BH
5
4
3
2
1
0
SAM5
SAM4
SAM3
SAM2
SAM1
SAM0
8.1.13 D_ch SAPI1 Register D_SAP1
Value after reset: 00H
7
6
SA17
SA16
SA15
Read/Write Address 0CH
5
4
3
2
1
0
SA14
SA13
SA12
SA11
SA10
相關PDF資料 |
PDF描述 |
|---|---|
| W6691 | ISDN S/T Interface Transceiver |
| W6691CD | ISDN S/T Interface Transceiver |
| W6691CP | ISDN S/T Interface Transceiver |
| W6692 | PCI Bus ISDN S/T Interface Controller(PCI總線的ISDN S/T接口控制器) |
| W6693A | USB Bus ISDN S/T Interface Controller(USB總線的ISDN S/T接口控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W6691CD | 制造商:WINBOND 制造商全稱:Winbond 功能描述:ISDN S/T Interface Transceiver |
| W6691CP | 制造商:WINBOND 制造商全稱:Winbond 功能描述:ISDN S/T Interface Transceiver |
| W6692 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCI Bus ISDN S/T-Controller |
| W6692A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TE Mode S/T Controller with PCI 2.2 Interface and ACPT |
| W6692ACD | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ISDN LINE INTERFACE|BASIC|CMOS|QFP|100PIN|PLASTIC |
發布緊急采購，3分鐘左右您將得到回復。