- 您現在的位置：買賣IC網 > PDF目錄363893 > W66910CD (WINBOND ELECTRONICS CORP) TE Mode ISDN S/T-Controller with Microprocessor Interface PDF資料下載
參數資料
| 型號： | W66910CD |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 通信及網絡 |
| 英文描述： | TE Mode ISDN S/T-Controller with Microprocessor Interface |
| 中文描述： | SPECIALTY TELECOM CIRCUIT, PQFP100 |
| 封裝： | 14 X 20 MM, 1.40 MM HEIGHT, QFP-100 |
| 文件頁數： | 68/81頁 |
| 文件大?。?/td> | 681K |
| 代理商： | W66910CD |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁當前第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁
Data Sheet
W66910 PCI ISDN S/T-Controller
Publication Release Date:
Feb,2001
Revision 1.0
-68 -
0: The data rate in B1 channel is 64 kbps.
1: The data rate in B1 channel is 56 kbps. The most significant bit in each octet is fixed at "1".
Note
: In 56 kbps mode, only transparent mode can be used.
FTS1-0 FIFO Threshold Select
These two bits determine the B1 channel receive and transmit FIFO's threshold setting. An interrupt is generated when the
number of received data or the number of vacancies in XFIFO reaches the threshold value.
FTS1
FTS0
Threshold (byte)
0
0
64
0
1
Reserved
1
0
96
1
1
Not allowed
8.2.5 B1_ch Extended Interrupt Register B1_EXIR
Value after reset: 00H
7
6
5
RMR
RME
RDOV
RMR Receive Message Ready
At least a hreshold lenth of data has been stored in the B1_RFIFO.
RME Receive Message End
Used in transparent mode only. The last block of a frame has been received. The frame length can be found in B1_RBCH +
B1_RBCL registers. The number of data available in the B1_RFIFO equals frame lenth modulus threshold. The result of CRC
check is indicated by B1_STAR:CRCE bit.
When the number of last block of a frame equals the threshold, only RME interrupt is generated.
RDOV Receive Data Overflow
Data overflow occurs in the receive FIFO. The incoming data will overwrite the data in the receive FIFO.
XFR Transmit FIFO Ready
This interrupt indicates that up to a threshold length of data can be written into the B1_XFIFO.
XDUN Transmit Data Underrun
This interrupt occurs when the B1_XFIFO has run out of data. In this case, the W66910 will automatically reset the transmitter
and send the inter frame time fill pattern on B channel. The software must wait until transmit FIFO ready condition (via XFR
interrupt), re-write data, and issue XMS command to re-transmit the data.
Read_clear
Address 24H
4
3
2
1
0
XFR
XDUN
相關PDF資料 |
PDF描述 |
|---|---|
| W6691 | ISDN S/T Interface Transceiver |
| W6691CD | ISDN S/T Interface Transceiver |
| W6691CP | ISDN S/T Interface Transceiver |
| W6692 | PCI Bus ISDN S/T Interface Controller(PCI總線的ISDN S/T接口控制器) |
| W6693A | USB Bus ISDN S/T Interface Controller(USB總線的ISDN S/T接口控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W6691CD | 制造商:WINBOND 制造商全稱:Winbond 功能描述:ISDN S/T Interface Transceiver |
| W6691CP | 制造商:WINBOND 制造商全稱:Winbond 功能描述:ISDN S/T Interface Transceiver |
| W6692 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCI Bus ISDN S/T-Controller |
| W6692A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TE Mode S/T Controller with PCI 2.2 Interface and ACPT |
| W6692ACD | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ISDN LINE INTERFACE|BASIC|CMOS|QFP|100PIN|PLASTIC |
發布緊急采購，3分鐘左右您將得到回復。