- 您現在的位置：買賣IC網 > PDF目錄363903 > W83977TF (WINBOND ELECTRONICS CORP) Multi-Function I/O Port Controller(用于個人計算機的多功能輸入/輸出口控制器) PDF資料下載
參數資料
| 型號： | W83977TF |
| 廠商： | WINBOND ELECTRONICS CORP |
| 英文描述： | Multi-Function I/O Port Controller(用于個人計算機的多功能輸入/輸出口控制器) |
| 中文描述： | 多功能I / O端口控制器（用于個人計算機的多功能輸入/輸出口控制器） |
| 文件頁數： | 73/160頁 |
| 文件大小： | 1012K |
| 代理商： | W83977TF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁當前第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁
W83977TF
PRELIMINARY
Publication Release Date: March 1998
- 64 -
Revision 0.62
5.3.15 DMA Transfers
DMA transfers are always to or from the ecpDFifo, tFifo, or CFifo. The DMA uses the standard PC
DMA services. The ECP requests DMA transfers from the host by activating the PDRQ pin. The DMA
will empty or fill the FIFO using the appropriate direction and mode. When the terminal count in the
DMA controller is reached, an interrupt is generated and serviceIntr is asserted, which will disable the
DMA.
5.3.16 Programmed I/O (NON-DMA) Mode
The ECP or parallel port FIFOs can also be operated using interrupt driven programmed I/O.
Programmed I/O transfers are to the ecpDFifo at 400H and ecpAFifo at 000H or from the ecpDFifo
located at 400H, or to/from the tFifo at 400H. The host must set the direction, state, dmaEn = 0 and
serviceIntr = 0 in the programmed I/O transfers.
The ECP requests programmed I/O transfers from the host by activating the IRQ pin. The
programmed I/O will empty or fill the FIFO using the appropriate direction and mode.
5.4 Extension FDD Mode (EXTFDD)
In this mode, the W83977TF changes the printer interface pins to FDC input/output pins, allowing the
user to install a second floppy disk drive (FDD B) through the DB-25 printer connector. The pin
assignments for the FDC input/output pins are shown in Table 5-1.
After the printer interface is set to EXTFDD mode, the following occur:
(1) Pins MOB and DSB will be forced to inactive state.
(2) Pins
DSKCHG
,
RDATA
,
WP
,
TRAK0
,
INDEX
will be logically ORed with pins PD4-PD0 to serve
as input signals to the FDC.
(3) Pins PD4-PD0 each will have an internal resistor of about 1K ohm to serve as pull-up resistor for
FDD open drain/collector output.
(4) If the parallel port is set to EXTFDD mode after the system has booted DOS or another operating
system, a warm reset is needed to enable the system to recognize the extension floppy drive.
5.5 Extension 2FDD Mode (EXT2FDD)
In this mode, the W83977TF changes the printer interface pins to FDC input/output pins, allowing the
user to install two external floppy disk drives through the DB-25 printer connector to replace internal
floppy disk drives A and B. The pin assignments for the FDC input/output pins are shown in Table5-1.
After the printer interface is set to EXTFDD mode, the following occur:
(1) Pins
MOA
,
DSA
,
MOB
, and
DSB
will be forced to inactive state.
(2) Pins DSKCHG, RDATA, WP, TRAK0, and INDEX will be logically ORed with pins PD4-PD0 to
serve as input signals to the FDC.
(3) Pins PD4-PD0 each will have an internal resistor of about 1K ohm to serve as pull-up resistor for
FDD open drain/collector output.
(4) If the parallel port is set to EXT2FDD mode after the system has booted DOS or another operating
system, a warm reset is needed to enable the system to recognize the extension floppy drive.
相關PDF資料 |
PDF描述 |
|---|---|
| W83C42 | Keyboard Controller(鍵盤控制器) |
| W83C43 | Keyboard Controller(鍵盤控制器) |
| W83C45 | Keyboard Controller(鍵盤控制器) |
| W83C553F | SYSTEM I/O CONTROLLER WITH PCI ARBITER |
| W83L177R | 100MHZ 2-DIMM SDRAM BUFFER FOR NOTEBOOK |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W83977TF(EOL) | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:W83877TF plus KBC. CIR. RTC |
| W83977TF_98 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:WINBOND I/O |
| W83977TF-A | 制造商:WINBOND 制造商全稱:Winbond 功能描述:I/O chip disk drive adapter |
| W83977TF-AW | 制造商:WINBOND 制造商全稱:Winbond 功能描述:WINBOND I/O |
| W83977TF-P | 制造商:WINBOND 制造商全稱:Winbond 功能描述:I/O chip disk drive adapter |
發布緊急采購，3分鐘左右您將得到回復。