- 您現在的位置：買賣IC網 > PDF目錄363893 > W6690 (WINBOND ELECTRONICS CORP) ISDN S/T Interface Controller(ISDN S/T接口控制器) PDF資料下載
參數資料
| 型號： | W6690 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 英文描述： | ISDN S/T Interface Controller(ISDN S/T接口控制器) |
| 中文描述： | 綜合業務數字網的S / T接口控制器（綜合業務數字網S / T的接口控制器） |
| 文件頁數： | 16/76頁 |
| 文件大小： | 471K |
| 代理商： | W6690 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁
Preliminary W6690
- 16 -
The transmitter and receiver are implemented by differential circuits to increase signal to noise ratio
(SNR). The nominal differential line pulse amplitude at 100
termination is 750 mV, zero to peak.
Transformers with 2:1 turn ration are needed at transmitter and receiver for voltage level translation
and DC isolation.
To meet the electrical characteristic requirements in I.430, some additional circuits are needed. At the
transmitter side, the external resistors (22 to 47
) are used to adjust the output pulse amplitude and
to meet the transmitter active impedance (
≥
20
when transmitting binary zeros). At the receiver
side, the 1.8 k
resistors protect the device inputs, while the 10 k
resistors (1.8 k
+8.2 k
) limit
the peak current in impedance tests. The diode bridge is used for overvoltage protection.
Figure 7.3 External Transmitter Circuitry
Figure 7.4 External Receiver Circuitry
After hardware reset, the receiver may enter power down state to save power. In thist state, the
internal clocks are turned off, but the analog level detector is still active to detect signal coming from
the S interface. The power down state is left either by non-INFO 0 signal from S interface or C/I
command from micro-processor.
SX1
SX2
22-47
22-47
GND
ο
V
DD
2:1
100
SR1
SR2
1.8k
1.8k
GND
ο
V
DD
8.2k
8.2k
2:1
100
相關PDF資料 |
PDF描述 |
|---|---|
| W66910CD | TE Mode ISDN S/T-Controller with Microprocessor Interface |
| W6691 | ISDN S/T Interface Transceiver |
| W6691CD | ISDN S/T Interface Transceiver |
| W6691CP | ISDN S/T Interface Transceiver |
| W6692 | PCI Bus ISDN S/T Interface Controller(PCI總線的ISDN S/T接口控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W6690ASX-1 | 制造商:Magnecraft 功能描述:Relay SSR 280V AC-IN 90A 660V AC-OUT 4-Pin |
| W6690DSX-1 | 制造商:Magnecraft 功能描述:Relay SSR 16mA 32V DC-IN 90A 660V AC-OUT 4-Pin |
| W6691 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:ISDN S/T Interface Transceiver |
| W66910 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| W66910CD | 制造商:WINBOND 制造商全稱:Winbond 功能描述:TE Mode ISDN S/T-Controller with Microprocessor Interface |
發布緊急采購，3分鐘左右您將得到回復。