- 您現在的位置：買賣IC網 > PDF目錄363904 > W89C940 (WINBOND ELECTRONICS CORP) ELANC-PCI (TWISTED-PAIR ETHER-LAN CONTROLLER WITH PCI INTERFACE) PDF資料下載
參數資料
| 型號： | W89C940 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 英文描述： | ELANC-PCI (TWISTED-PAIR ETHER-LAN CONTROLLER WITH PCI INTERFACE) |
| 中文描述： | ELANC -的PCI（雙絞線醚局域網控制器帶有PCI接口） |
| 文件頁數： | 10/61頁 |
| 文件大小： | 353K |
| 代理商： | W89C940 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁
W89C940
10
Normally, the data in the FIFO cannot be read; reading FIFO data during normal operation may cause the
system to hang. In loopback mode, however, the SLCT allows FIFO data to be read by byte in order to check
the correctness of the loopback operation.
Receive Logic
The receive logic is responsible for receiving the serial network data and packing the data in byte/word
sequence. The receive logic thus has serial to parallel logic in addition to network detection capability.
The ELANC-PCI accepts both physical addresses and group addresses (multicast and broadcast addresses).
The SLCT extracts the address field from the serial input data. It then determines if the address is acceptable,
according to the configurations defined in the receive configuration register (RCR). If the address is not
acceptable, the packet reception is aborted. If the address is acceptable, the data packet is sent to the serial to
parallel logic before being fed into the FIFO. Data packets can thus be processed either byte or word-wide.
After receiving a data packet, the SLCT automatically adds four bytes of data receive status, next packet
pointer, and two bytes of receive byte count into the FIFO for network management purposes. The receive
status contains the status of the incoming packet, so that the system can determine if the packet is desired. The
next packet pointer points to the starting address of the next packet in the local receive ring. The receive byte
count is the length of the packet received by the SLCT. Note that the receive byte count may be different from
the "length" field specified in the Ethernet packet format. These four bytes of data will be transferred to the local
buffer with the last batch of the local DMA. However, these four bytes are stored at the first four addresses
before the packet.
Transmit Logic
The SLCT must be filled before transmission begins. That is, the local DMA read must begin before the SLCT
begins transmission. The SLCT first transmits 62 bits of preamble, then two bits of SFD, and then the data
packet. The parallel to serial logic serializes the data from the FIFO into a data packet. After the data packet,
the SLCT optionally adds four bytes of cyclic redundancy code (CRC) to the tail of the packet.
A protocol PLA determines the network operations of the ELANC-PCI. Collision detection, random backoff, and
auto retransmit are implemented in the transmit logic. The protocol PLA ensures that the ELANC-PCI follows
IEEE 802.3 protocol.
10BASE2 AND 10BASE5 PLS (PHYSICAL LAYER SIGNAL) FUNCTION
SNA Operation
TP
or
Coax
AUI
Interface
PLL
Manchester
Encoder/Decoder
osc/
crytal
SLCT Interface
Logic
L
C
E
相關PDF資料 |
PDF描述 |
|---|---|
| W89C982 | INTEGRATED MULTIPLE REPEATER II |
| W89C982AF | INTEGRATED MULTIPLE REPEATER II |
| W8NB80 | N - CHANNEL 800V - 1.2ohm - 7.5A - TO-247 PowerMESH MOSFET |
| W90100F | Embedded Micro-Controller(32位嵌入式的微控制器) |
| W90210F | PA-RISC Embedded Micro-Controller(惠普PA-RISC結構的32位嵌入式微控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W89C940F | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10M PCI-Bus Ethernet Network Interface Controller |
| W89C982 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:INTEGRATED MULTIPLE REPEATER II |
| W89C982AF | 制造商:WINBOND 制造商全稱:Winbond 功能描述:INTEGRATED MULTIPLE REPEATER II |
| W8C2-DNL | 制造商:Hwei Lung Precision Machinery 功能描述:TORCH 8 LED BLACK 2C |
| W8D10PF29033 | 制造商:TE Connectivity 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。