国产精品成人VA在线观看-国产乱妇乱子视频在播放-国产日韩精品一区二区三区在线-国模精品一区二区三区

參數資料
型號: W88113C
廠商: WINBOND ELECTRONICS CORP
英文描述: ATAPI CD-ROM DECODER & CONTROLLER
中文描述: ATAPI的CD - ROM解碼器
文件頁數: 17/102頁
文件大小: 573K
代理商: W88113C
W88113C
Publication Release Date: Mar. 1999
- 13 - Revision 0.61
2. REGISTERS DESCRIPTION
IR - Index Register (read/write)
If
DRA (5Bh.1)
is high, the Index Register is latched at the falling edge of
pin ALE1 (5)
or
pin ALE2
(64)
depending on the setting of
ALE2 (5Ch.3).
If
DRA (5Bh.1)
is low and
pin URS (32)
is low, the Index Register can be accessed by the
microprocessor. The value in IR specifies which internal register to be accessed by microprocessor
when
pin URS (32)
is high.
Note that the 4 least significant bits of IR will increment following each read or write to any register except for
PFAR (00h,r)
. Since IR
does not automatically increment from 00h to 01h, consecutive reads to address 00h will repeatedly read register
PFAR (00h,r)
. This
feature accelerates read operation of ATAPI Command Packet.
PFAR - Packet FIFO Access Register - (read 00h)
While
SCoD (20h.2)
is high, the ATAPI Command Packet issued from host is received by the 12-byte
Packet FIFO. Flag
TENDb (01h.r6)
is used to check if the Packet FIFO is full. The microprocessor
can read the ATAPI Command Packet by repeatedly read register
PFAR (00h,r)
. Once the FIFO
becomes empty, the value FFh will be returned if microprocessor read PFAR.
The Packet FIFO can also be used to receive command parameter less than 12 bytes. First, the
control bit
SCoD (20h.2)
is set high to select the Packet FIFO to be addressed by the ATAPI Data
port. When
DRQ (37h.3)
changes from 0 to 1, the lower 4 bits of
ATBLO (34h)
is latched as the FIFO
threshold. Upon the number of bytes in the FIFO reaches the threshold, flag
TENDb (01h.r6)
becomes active-low and flag
FPKT (30h.r1)
becomes active-high. Once FPKT becomes high, any
data writes to the ATAPI Data port is rejected.
INTCTL - Interrupt Control Register - (write 01h)
Bit 7:
PFNEEN - Packet FIFO Not Empty Interrupt Enable
Pin UINTb (36)
is activated when
PFNEb(01h.r7)
becomes active-low if this bit is high.
Bit 6:
TENDEN - Transfer End Interrupt Enable
Pin UINTb (36)
is activated when
TENDb (01h.r6)
becomes active-low if this bit is high. This
bit is also automatically enabled if the host issues the Packet Command (A0h) while
HIIEN
(2Eh.w7)
is high and drive is selected.
Bit 5:
SRIEN - Sector Ready Interrupt Enable
Pin UINTb (36)
is activated when
SRIb (01h.r5)
becomes active-low if this bit is high. This bit
is clear to 0 after chip reset, host reset, firmware reset and decoder reset.
相關PDF資料
PDF描述
W88113CD ATAPI CD-ROM DECODER & CONTROLLER
W88113CF ATAPI CD-ROM DECODER & CONTROLLER
W88227F ATAPI CD-ROM Decoder(支持ATAPI標準的CD-ROM解碼器)
W88227QD ATAPI CD-ROM Decoder(支持ATAPI標準的CD-ROM解碼器)
W88611P VCD 4X RF Amplifer/Digital Servo & DSP(具有射頻運算放大器及數字信號伺服和處理的集成芯片)
相關代理商/技術參數
參數描述
W88113CD 制造商:WINBOND 制造商全稱:Winbond 功能描述:ATAPI CD-ROM DECODER & CONTROLLER
W88113CF 制造商:WINBOND 制造商全稱:Winbond 功能描述:ATAPI CD-ROM DECODER & CONTROLLER
W88611P 制造商:WINBOND 制造商全稱:Winbond 功能描述:VCD 4X RF AMP/DIGITAL SERVO & DSP
W88631F 制造商:WINBOND 制造商全稱:Winbond 功能描述:VCD 4X RF AMP/DIGITAL SERVO & DSP
W88980 制造商:Performance Tool 功能描述:Anti-Fatigue Floor Mat Roll - 12 Square Feet 制造商:PERFORMANCE TOOLS 功能描述:ANTI-FATIGUE FLOOR MAT ROLL 12 SQ FT